Honeywell D1-528 Direct Thermostat Installation Guide
INNCOM DIRECT D1-528 THERMOSTAT INSTALLATION GUIDE
2. Press DISPLAY button to store the setting, the
D1-528 beeps to confirm it is set.
Deploy the Property Key
The Unique Property Key for the hotel must be deployed
to the D1-528 in all rooms.
The OUTSIDE symbol will start blinking on the
D1-528 display, indicating that the changes made
need to be saved.
Why the Property Key is Required:
3. Press the F/C button.
Str (store) appears on the display indicating that the
changes made need to be stored.
If there is a nearby hotel which is also using INNCOM’s
RF network and RF devices, there is a possibility that
interference and crosstalk can occur between the
INNCOM RF devices in both hotels. To prevent this a
unique automatically generated, hotel specific property
key is assigned to the D1-528. Any RF messages sent
between the D1-528 and D-578 Edge Router in one
hotel contain this unique property key and will be
ignored/rejected in any other nearby INNCOM
installations.
4. Press DISPLAY button to store the changes.
D1-528 will reset (the display will go blank then turn
back on).
Checking Functionality
1. HVAC: Test cool and heat operations and all available
fan speeds
2. PIR (motion sensor:
Configuration at the D-578 Edge Router:
Enter Service Parameter mode and go to the Pir
parameter and perform the PIR Motion Sensor Test
(Plr).
1. Install and power the D-578 Edge Router.
2. Activate Property Key Deployment mode on the D-
578.
3. If monitoring room entry door position, perform the
Entry Door Test. Enter Service Parameter mode and
go to the dor parameter and perform the Door Test
(dor).
This will cause the D-578 to broadcast a unique
property key. Any D1-528 that is not using the new
property key will automatically switch to it.
4. If the INNCOM server (or Niagara JACE controller) is
installed and running the Niagara Service and the D-
578 Edge Router is installed, perform the D1-528
WAN test to verify the D1-528 is communicating with
Niagara. Enter Service Parameter mode, go to the
rUn menu and execute Parameter 7: WAN (Wide Area
Network) test.
To Deploy the Property Key to the D1-528:
NOTE:
A brief summary of the D-578 installation is
provided here. For full details refer to the INNCOM
D-578 Edge Router Installation Instructions 31-
00720.
Go to the next room to configure the D1-528. If this was
the last room, go to the next section, Room
Configuration Complete.
1. Start the Niagara service on the INNCOM server PC
(or Niagara JACE box if using that) if not running.
2. Install and power the D-578 Edge Router and
connect it to the assigned port on the network switch
defined by the hotel.
Room Configuration Complete
The initial installation and configuration of the D1-
528’s in the rooms is complete. If the INNCOM server
PC (or JACE controller) is installed and configured and
the D-578 Edge Router has been installed and
configured , you can open and log into the Honeywell
Remote Building Manager (RBM) site for your
installation and see the rooms online. Room 106 is
Online in the below example.
The D-578 can be powered from an external 12 VDC
power supply connected to the 12 VDC jack on the
D-578, or powered via PoE (power over ethernet) if
the network switch supports PoE.
The D-578 has 2 communication channels.
• A wired UDP Port 23211 network connection
that connects the D-578 to the Niagara
Gateway/Niagara service running on the
INNCOM PC installed at the hotel.
• A wireless ZigBee RF network that connects the
D1-528 “Room Gateway” in each room to the
D-578.
By default, the D-578 expects to obtain its IP Address
automatically from a DHCP server installed on the
hotels network.
The yellow D4 LED will blink rapidly, when the D-578 is
connected to Niagara.
3. Press the Blue bind button 6 times to place the
D-578 into Key Distribution Mode.
31-00721-01
16
| General | Details |
|---|---|
| Name | Honeywell D1-528 Direct Thermostat Installation Guide |
| Make | Honeywell |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.63 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Honeywell T6 Pro Programmable Thermostat User Manual
Honeywell FocusPRO P200 Programmable Thermostat User Guide
Honeywell RCHT8610WF Series Smart Thermostat Installation Guide
Honeywell T9 Smart Thermostat Installation Guide
Honeywell TH2320WF4011 FocusPRO Smart S200 Series Thermostat User Guide
Honeywell TL116A Thermostat Installation Guide
T10 Pro Smart Thermostat with Redlink Room Sensor
Honeywell TH6320WF2003 Lyric T6 Pro Wi-Fi Programmable Thermostat User Guide
Honeywell Smart Color Touchscreen Programmable Thermostat RTH9590 User Manual
Honeywell RTH2510/RTH2410 Thermostat Installation Guide
Living Heat T5 Touch Screen Digital Smart Thermostat Instructions
KETOTEK LL0269 WiFi Digital Heating Thermostat User Manual
MRCOOL Mini-Stat WiFi Thermostat User Manual
KETOTEK KTF017802 Smart WiFi Thermostat Instructions
EPH CONTROLS CDT2-24 Room Thermostat Instruction Manual
GENERAL LIFE HT220 Smart Digital Room Thermostat User Manual
ecobee M5A Smart Wi-Fi Thermostat User Guide
Haswill Electronics STC-8080H Thermostat User Guide
MYSON Unisenza Digital Thermostat User Manual
Honeywell 69-2384ES-01 RTH111 Non Programmable Thermostat Installation Guide