HASWILL ELECTRONICS STC-200 Thermostat User Guide

1

2

3

STC-200 Thermostat  

Quick Start Guide  

Video on YouTube  

(Version 23.03.03GEN)  

STC-200+ thermostat with just one relay to control the  

power supply status of the wired heater or cooler or  

output alarm.  

1. Wiring Diagram  

2. Set the Aimed Temp Range  

The aimed temperature range was defined from “SP” to  

“SP + F0”; hence you need to set both the “SP” and the  

“F0” value.  

1 / 3  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	HASWILL ELECTRONICS STC-200 Thermostat User Guide
Make	HASWILL ELECTRONICS
Language	English
Filetype	PDF (Download)
File size	0.09 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL THERMOSTAT INSTRUCTIONS & USER MANUALS
• HASWILL ELECTRONICS

HASWILL ELECTRONICS STC-200 Thermostat User Guide Overview

Summary of Contents

• Page 1: STC-200 thermostat Quick start guide STC-200+ thermostat with just one relay to control the power supply status of the wired heater or cooler or output alarm. Wiring diagram Set the aimed temp range The aimed temperature range was defined from “SP” to “SP + F0”; hence you need to set both the “SP” and the “F0” value.
• Page 2: Function Temperature hysteresis / difference Protection delay time for the compressor Lower limit for SP setting Upper limit for SP setting Refrigeration or heating or alarm mode Calibration = real - measured Set the “SP” value Set the “Hysteresis” value
• Page 3: Hold the key for 3 seconds to save data and return to normal monitor status. Repeat steps to change other settings. Hold the key for 3 seconds to quit from setting or leave it alone; it will revert to normal status in 30 seconds without operation. This is not a step-by-step user manual; it just shows the key points. The new user should read the full-content version user manual. Haswill Electronics STC-200+ Thermostat. Copyright Haswill-Haswell All Rights Reserved.