Home > Lennox > LENNOX S40 Smart Thermostat User Guide

LENNOX S40 Smart Thermostat User Guide

Lennox Smart Air Quality Monitor  
How the Smart Air Quality Monitor Works  
Status Indicator  
IMPORTANT  
The Lennox® S40 Smart Thermostat will begin displaying information from  
the Smart Air Quality Monitor once there is a blower/cooling/heating demand.  
Until the first thermostat demand, the SAQM will indicate it is calculating.  
Pairing Button /  
Factory Reset  
Side Switch  
Up = ON  
Down = OFF  
Side Air Vent  
Figure 25. SAQM Calculating  
Status Indicator Light Color Descriptions  
When the Smart Air Quality Monitor detects poor indoor air quality (IAQ) in  
the home it will pass that information on to the thermostat which will attempt  
to clean the air. Depending on the IAQ equipment installed in the home, one  
of the following methods will be used by the thermostat:  
NOTE: The light is only on if there is an issue with signal strength.  
Table 1. Sensor Light - Two Color Descriptions  
Light  
» If no IAQ equipment installed - The thermostat will run the indoor unit  
Function  
Description  
Color  
blower to circulate air.  
• A solid blue light indicates the signal strength is  
low or has lost connection to the thermostat.  
» High Efficiency Filter - The thermostat will run the blower motor to  
Signal  
Strength  
BLUE  
circulate the air through the filter cabinet.  
No blue light indicates signal strength is good.  
» Pure Air - The thermostat turns on system to run Pure Air to circulate  
the air through the Pure Air system.  
A flashing green light indicates the unit is in pairing  
mode.  
Pairing  
GREEN  
» ERV / HRV - The thermostat will check outdoor air quality and compare  
it to the indoor air quality. If outdoor air quality is better then it will bring  
in fresh outdoor air. If outdoor air is poorer it will run the indoor blower  
to circulate the indoor air.  
Adding and Removing the Smart Air Quality Monitor (SAQM)  
This device can only be installed by a professional installer. A single Lennox®  
Side Switch  
S40 Smart Thermostat can support one Lennox® Smart Air Quality Monitor.  
The primary reason for this switch is to turn off the internal fan in case the  
device is installed in a bedroom.  
40  
GeneralDetails
NameLENNOX S40 Smart Thermostat User Guide
MakeLennox
LanguageEnglish
FiletypePDF (Download)
File size1.3 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
LENNOX L40 Smart Thermostat Owner’s Manual
LENNOX L40 Smart Thermostat Owner’s Manual
LENNOX EL18KCV Smart Wi-Fi Communicating Thermostat User Manual
LENNOX EL18KCV Smart Wi-Fi Communicating Thermostat User Manual

LENNOX S40 Smart Thermostat User Guide