LENNOX S40 Smart Thermostat User Guide
Table 2. Home and Status Screens Icon Descriptions
Purpose
Function or
Screen Text
Icon
Defrosting
The heat pump system is defrosting the outdoor unit coil. Not available for non-heat pump systems.
All heat pumps operating in northern climates below 35°F (1.6°C) normally need a supplemental heating source. Usually
it is in the form of electric heating provided by the indoor unit. Other sources could be gas, oil, or hot-water back-up
systems as well. The supplemental heat is also referred to as “second-stage” or “back-up” heating, with “first-stage” being
the heat pump only. Emergency heat is supplemental heat (2nd stage) is used solely, without the use of a heat pump (1st
stage heat). Not available for non-heat pump systems.
Emergency
Heat
If outdoor temperature is above the high balance point, only the heat pump will operate - default 50°F (10°C) high. If
outdoor temperature is below the low balance point, only auxiliary heating will operate - default 25°F (-4.0°C) low. If
outdoor temperature is in-between the high and low balance point, both the heat pump and auxiliary heat sources can
operate. Not available for non-heat pump systems.
Auxiliary Heat
Will start soon
A five minute safety delay prevents the compressor from operating too soon after shut-down to allow internal pressures to
equalize.
This indicates that either the outdoor temperature is above or below the balance point temperature settings. The low
balance point setting prevents heat pump heating below the set point and back up heat will be used. Typically the default
is 25°F (-4.0°C), but that setting can be adjusted by the dealer. At 25°F (-4.0°C) or below for example, only auxiliary
heating (electric or gas) is used. If the high balance point is set to 50°F (10°C) for example, which is also adjustable by
the dealer, then auxiliary heat will not be allowed. Only heat pump heating will be used. Anytime the outdoor temperature
is below or above the balance point temperature settings, the ambient lockout notice will appear on the Home screen.
Ambient
lockout
Fan is running
Fan set to ON. Fan is NOT following the schedule and runs continuously until it is changed from the selected mode.
Fan in auto
mode is active
Fan set to Auto. Fan will follow the fan setting in the selected schedule.
Fan in circulate
mode is active
Fan set to Circulate. Fan is following schedule and cycles during periods of equipment inactivity. Circulate run time is
dependent on user settings.
20
| General | Details |
|---|---|
| Name | LENNOX S40 Smart Thermostat User Guide |
| Make | Lennox |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.3 MB |
(1 votes, average: 5.00 out of 5)
Loading...
LENNOX L40 Smart Thermostat Owner’s Manual
LENNOX EL18KCV Smart Wi-Fi Communicating Thermostat User Manual
Honeywell Programmable Thermostat T4 Pro Installation Guide
GENERAL LIFE SENNA 270S Digital Room Thermostat User Manual
Thalos Key 230 Bianco Touch Screen Wall Thermostat Instruction Manual
BOSCH BCC110 Thermostat User Guide
GENERAL LIFE FH10 Underfloor Heating Thermostat User Manual
Honeywell RTH8500 Wifi Thermostat User Manual
Global Sources WT598 1T1 Smart Thermostat Instructions
emos P5616OT Wireless Thermostat Instruction Manual
White-Rodgers 1E78 Non Programmable Heat Only Thermostat User Manual
WATTS WTC-ES Contact Thermostat User Manual