Home > WHITE RODGERS > White-Rodgers 1E78 Non Programmable Heat Only Thermostat User Manual

White-Rodgers 1E78 Non Programmable Heat Only Thermostat User Manual

CAUTION  
Take care when securing and routing wires so they do  
not short to adjacent terminals or rear of thermostat.  
Personal injury and/or property damage may occur.  
!
REMOVING OLD THERMOSTAT  
continued from first page  
3
ATTENTION! This product does not contain mercury. How-  
ever, this product may replace a unit which contains mercury.  
Do not open mercury cells. If a cell becomes damaged, do  
not touch any spilled mercury. Wearing non-absorbent gloves,  
take up the spilled mercury and place into a container which  
can be sealed. If a cell becomes damaged, the unit should be  
discarded.  
TERMINAL CROSS REFERENCE CHART  
Other Manufacturers’  
Terminal Designation  
New Thermostat  
Terminal Designation  
RH  
W
4
W
RH  
W
M
H
Mercury must not be discarded in household trash. When the  
unit this product is replacing is to be discarded, place in a suit-  
send product containing mercury.  
Attach Thermostat Base to Wall  
1. Remove the packing material from the thermostat. Gently  
pull the body straight off the base. Forcing or prying on the  
thermostat will cause damage to the unit.  
MOUNTING AND WIRING  
4
2. Connect wires beneath terminal screws on base using ap-  
propriate wiring schematic (see fig. 2).  
3. Place base over hole in wall and mark mounting hole loca-  
tions on wall using base as a template.  
WARNING  
!
Do not use on circuits exceeding specified voltage.  
Higher voltage will damage control and could cause  
shock or fire hazard.  
4. Move base out of the way. Drill mounting holes.  
5. Fasten base loosely to wall, as shown in fig. 1, using two  
mounting screws.Adjust until level, and then tighten screws.  
(Levelingisforappearanceonlyandwillnotaffectthermostat  
operation.)Ifyouareusingexistingmountingholes,orifholes  
drilled are too large and do not allow you to tighten base  
snugly, use plastic screw anchors to secure subbase.  
Do not short out terminals on gas valve or primary  
control to test. Short or incorrect wiring will  
damage thermostat and could cause personal injury  
and/or property damage.  
Thermostat installation and all components of the  
system shall conform to Class II circuits per the  
NEC code.  
6. Push excess wire into wall and plug hole with a fire-resistant  
material(suchasberglassinsulation)topreventdraftsfrom  
affecting thermostat operation.  
Battery Location  
Hydronic (Hot Water or Steam)  
Heating Systems  
This thermostat requires 2 “AAA” alkaline batteries to operate.  
Thisthermostatissettooperateproperlywithaforced-airheating  
system. If you have a hydronic heating system (a system that  
heats with hot water or steam), you must set the thermostat to  
operate properly with your system.  
If  
appears on the display, the batteries are low  
and should be replaced with fresh “AAA” Energizer® alkaline  
batteries.Thebatteriesarelocatedonthebackofthethermostat  
body (see fig. 1).  
The factory default setting is forced air heat. Clipping jumper  
W905 on the circuit board will produce a longer heating cycle  
whichisnormallyforhotwaterorsteam(hydronic)systems.Both  
settings produce a very accurate temperature control and can  
be set to your personal preference. As received, the thermostat  
cycles the system just under 1°F.WithW905 clipped, the system  
cycles at approximately 1.5°F.  
JUMPER  
WIRE  
THERMOSTAT  
Y
B
O
G
W
RC  
RH  
SYSTEM  
Heating  
System  
Hot  
24 VAC  
120 VAC  
Neutral  
TRANSFORMER  
Figure 2. Typical wiring diagram for  
heat only, 2-wire, single transformer systems  
2
GeneralDetails
NameWhite-Rodgers 1E78 Non Programmable Heat Only Thermostat User Manual
MakeWHITE RODGERS
LanguageEnglish
FiletypePDF (Download)
File size0.27 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
White-Rodgers 1F97-1277 Big Blue Single Stage Thermostat User Manual
White-Rodgers 1F97-1277 Big Blue Single Stage Thermostat User Manual
White-Rodgers 1F56N-444 Thermostat User Manual
White-Rodgers 1F56N-444 Thermostat User Manual
White-Rodgers 1F83-277 Heating & Air Conditioning Auto Changeover Heat Pump Thermostat User Manual
White-Rodgers 1F83-277 Heating & Air Conditioning Auto Changeover Heat Pump Thermostat User Manual
White-Rodgers M30 Thermostat Instruction Manual
White-Rodgers M30 Thermostat Instruction Manual
WHITE-RODGERS 1F51N-619 Low Voltage Evaporative Cooler Thermostat Instruction Manual
WHITE-RODGERS 1F51N-619 Low Voltage Evaporative Cooler Thermostat Instruction Manual
WHITE-RODGERS 1F86-0471 Blue Single 1 1 Stage Thermostat Instruction Manual
WHITE-RODGERS 1F86-0471 Blue Single 1 1 Stage Thermostat Instruction Manual
WHITE-RODGERS 1F90-71 5-Day 2-Day Electronic Digital Thermostat Instruction Manual
WHITE-RODGERS 1F90-71 5-Day 2-Day Electronic Digital Thermostat Instruction Manual
WHITE-RODGERS 1F95-1277 Universal Thermostat Owner’s Manual
WHITE-RODGERS 1F95-1277 Universal Thermostat Owner’s Manual
White Rodgers 1F78-151 Non Programmable Thermostat Instructions
White Rodgers 1F78-151 Non Programmable Thermostat Instructions
WHITE RODGERS 1F80-51 Programmable Electronic Digital Thermostat Instruction Manual
WHITE RODGERS 1F80-51 Programmable Electronic Digital Thermostat Instruction Manual

White-Rodgers 1E78 Non Programmable Heat Only Thermostat User Manual