6. Over-current Alarm(Max Floor Temp → Hysterersis → Key Vibration → Display Brightness Set → Display Auto Off)
7. Temperature Set(Temperature Compensation → Re-power Status → Internal Over Heat Protection → Child Lock → Display Auto Off Function)
8. Z-wave Set Introduction(Z-wave Network Management → Adding To A Z-wave Network (inclusion) → Removing From A Z-wave Network (exclusion) → Factory Reset (reset) → Basic Set Command Class → Z-wave Technical Specifications)
9. Device Type(Specific Device Class → Supported Command Class → Root Device → Suppourt Command Class → Controlled Command Class)
10. Endpoint1 Command List(Endpoint2 Command List → Support Command Class → Command_class_zwaveplus_info → Command_class_security → Association → Root Device)
11. Endpoint01(Endpoint02 → Advance Config Parameters → Monitor Set → Other Set)
12. Time Interval Value For Periodic Report Of Temperature, Humidity(When To Report Power Change Absolute Threshold → When To Report Current Change Absolute Threshold → When To Report Voltage Change Absolute Threshold → Time Interval Value For Periodic Active Report Of Meter → The Oled Display Brightness When Operate The Device → Other Set)