Home > SMART TEMP > SMART TEMP SMT-131 Hotel Touchscreen Thermostat User Manual
×
- 1. Smt - 131 (Manual → Ver 2.7)
- 2. Revision History (Introduction → Thermostat Operation → Installation - Hvac Control → Dip Switch Settings → Wiring Hvac Control → Belimo 6 Way Valve)
- 3. Introduction (Thermostat Operation → Set Temperature → Fan)
- 4. Option 16 In The Installer Menu Permits You To Set The Smt-131 To Automatically Reset The Indoor Fan To Automatic Mode (cycle On And Off Wit… (Ventilation Mode → Make Up Room & Do Not Disturb Buttons → Installation - Hvac Control → System Design → Opening Wall Controller → Mounting Wall Controller)
- 5. Dip Switch Settings (Wiring - Hvac Control)
- 6. Caution
- 7. 10v Outputs (A1 Cool → A2 Heat → A3 Fan → Span → Time Interval → Direction)
- 8. Maximum Value (fan A3) Output Only (Belimo 6 Way Valve → Pipe Mode)
- 9. Klixon Mode / 2 Pipe (Ancillary Functions → Complete System Overview)
- 10. Occupancy Detection (Window Contact → Fault Indication)
- 11. Door Switch (Entering Or Exiting The Room → Door Left Open → Pir Input → Latched Occupancy Detection Logic)
- 12. Occupied Mode (Un-occupied Mode → Installer Option 'pir Input Delay' → Using A Pir Only For Occupancy Detection → Steps To Use The Smt-131 In Automatic Occupancy Detection Mode → Manual Occupancy Input → Doorbell)
- 13. Outside Door Station (Automatic Day Set Temperature → Modbus Wiring)
- 14. Modbus Data (Remote Temperature Sensors)
- 15. Installer Options Menu (Navigating Through The Installer Mode Settings → Option List Table)
- 16. High Temp Set Limit (Low Temp Set Limit → Dead Band → Fan Purge / Run On Period → Fan Span → Heat Span → Cool Span)
- 17. Unoccupied Fan Mode (Backlight → Temperature Calibration → Digital Input → Window Input Logic → Door Input Logic → Pir Input Delay)
- 18. Thermostat Response To Changes In Room (Firmware → Temperature Calibration → Factory Reset → Modbus Data Addendum 1)
- 19. Data Format (Protocol → Modbus Rtu (slave) → Byte Format → Device Id → Occupancy Status → Fan Status)
- 20. Read/write Room Temperature (Temperature Display → User Set Point High Limit → User Set Point Low Limit → Dead Band → Fan Purge Period → Auto Off Timer)
- 21. Unoccupied Fan Mode (Fan Speed Mode → Backlight → Digital Input Function → Reset Fan Mode → Belimo Mode → Modbus Address)
- 22. Modbus Control Of Outputs (Permitted Modes → Relay Status → 10v Heat Value → 10v Cool Value → Displaying)
- 23. Hide Both Mode And Fan Buttons
- 24. Permitted Modes (Fan Span → Window Input Logic → Window Input Delay → Door Input Logic → Door Input Delay → Unit Run Time Log)
- 25.
- 26. Specifications (Input Voltage → Operating Temperature → Operating Rh → Storage Temperature → Size → Display Size)
×
SMART TEMP SMT-131 Hotel Touchscreen Thermostat User Manual
| General | Details |
|---|---|
| Name | SMART TEMP SMT-131 Hotel Touchscreen Thermostat User Manual |
| Make | SMART TEMP |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.34 MB |

SMT-2W5 Smart Temp Wifi Thermostat Instruction Manual

Smart Temp SMT-850 Halo Thermostat User Guide

Smart Temp SMT-450 Flexistat WiFi Thermostat Instructions


HERSCHEL T-MT Mains Powered WiFi Thermostat Instruction Manual

PURGEAR STC-2304 Digital Thermostat User Guide

Micro-Air EasyTouch RV 353 Thermostat Instruction Manual

Honeywell T140 7-Day Programmable Wired Thermostat User Guide
STELPRO SAT402ZB Smart Thermostat User Guide

PRO1 T771 Programmable Electronic Thermostat Instructions

Wyze Thermostat User Guide

LUX DHP2120 Battery Powered Non Programmable Digital Heat Pump Thermostat Installation Guide

EVERBILT Electric Upper Thermostat Instructions

MI-HEAT E51 Thermostat User Manual
Table of Contents
- 1. Smt - 131 - Manual →
- 2. Revision History - Introduction →
- 3. Introduction - Thermostat Operation →
- 4. Option 16 In The Installer Menu Permits You To Set The Smt-1... →
- 5. Dip Switch Settings - Wiring - Hvac Control →
- 6. Caution →
- 7. 10v Outputs - A1 Cool →
- 8. Maximum Value (fan A3) Output Only - Belimo 6 Way Valve →
- 9. Klixon Mode / 2 Pipe - Ancillary Functions →
- 10. Occupancy Detection - Window Contact →
- 11. Door Switch - Entering Or Exiting The Room →
- 12. Occupied Mode - Un-occupied Mode →
- 13. Outside Door Station - Automatic Day Set Temperature →
- 14. Modbus Data - Remote Temperature Sensors →
- 15. Installer Options Menu - Navigating Through The Installer Mo... →
- 16. High Temp Set Limit - Low Temp Set Limit →
- 17. Unoccupied Fan Mode - Backlight →
- 18. Thermostat Response To Changes In Room - Firmware →
- 19. Data Format - Protocol →
- 20. Read/write Room Temperature - Temperature Display →
- 21. Unoccupied Fan Mode - Fan Speed Mode →
- 22. Modbus Control Of Outputs - Permitted Modes →
- 23. Hide Both Mode And Fan Buttons →
- 24. Permitted Modes - Fan Span →
- 25. Page 25 →
- 26. Specifications - Input Voltage →





























