Home > OH > OH-1202H Universal Humidity Touchscreen Thermostat Instruction Manual

OH-1202H Universal Humidity Touchscreen Thermostat Instruction Manual

INSTALLATION  
Thermostat Power Method  
Switch Position/Description  
WARNING  
!
Battery Powered, no 24  
Volt system power available.  
Switches "On", thermostat  
runs on batteries.  
Thermostat installation and all components of the  
control system shall conform to Class II circuits per  
the NEC code.  
Hardwired with Battery  
Switches "On", thermostat  
Back-up, for 24 Volt systems runs on power directly from  
with common connection from transformer with battery back-  
transformer to "C" terminal  
on thermostat.  
up.  
Remove Old Thermostat  
Before removing wires from old thermostat, mark wires for  
terminal identification so the proper connections will be made  
to the new thermostat.  
*Battery Powered with  
Power Stealing Assist,  
for 24 Volt systems with no  
common connection from  
transformer to "C" terminal on  
thermostat.  
Switches "On", thermostat  
runs on batteries and  
supplemental power drawn  
through the heat or cool circuit.  
Installing New Thermostat  
1. Pull the thermostat body off the thermostat base. Forcing  
or prying on the thermostat will cause damage to the unit.  
*Power Stealing Assist is very reliable to increase battery life,  
but on a small number of heating or cooling systems with high  
impedance electronic modules you may observe one of the  
following conditions:  
2. Place base over hole in wall and mark mounting hole  
locations on wall using base as a template.  
3. Move base out of the way. Drill mounting holes. If you  
are using existing mounting holes and the holes drilled  
are too large and do not allow you to tighten base snugly,  
use plastic screw anchors to secure the base.  
1. The furnace draft inducer motor may run with no call for  
heat.  
2. The furnace fan may turn on with no call for heat or may  
not turn off.  
4. Fasten base snugly to wall using mounting holes shown  
in Figure 1 and two mounting screws. Leveling is for  
appearance only and will not affect thermostat operation.  
3. The furnace may not turn off when the call for heat ends.  
4. The air conditioner may not turn off when the call for cool  
ends.  
5. Connect wires to terminal block on base using appropriate  
wiring schematic.  
If the Power Stealing Assist method is not compatible with  
your system, place the Power Stealing Switches to "Off". This  
cancels Power Stealing Assist, operates the thermostat on  
batteries and corrects the condition.  
6. Push excess wire into wall and plug hole with a fire resis-  
tant material (such as fiberglass insulation) to prevent  
drafts from affecting thermostat operation.  
7. Carefully line the thermostat up with the base and snap  
into place.  
Figure 1 – Thermostat Base Multi-Stage  
Battery Location  
2 "AA" alkaline batteries are included in the thermostat at the  
factory with a battery tag to prevent power drainage. Remove  
the battery tag to engage the batteries.  
+
O/B  
S
Mounting  
Hole  
Mounting  
Hole  
L
Y2  
Y
-
To replace batteries, set system to OFF, remove thermostat  
from wall and install the batteries in the rear along the top  
of the thermostat (see Figure 1). For best results, use a  
premium brand "AA" alkaline battery such as Duracell® or  
Energizer®. If the home is going to be unoccupied for an  
HM  
W2  
W/E  
6
DHM  
extended period (over 3 months) and is displayed, the  
batteries should be replaced before leaving.  
Place Level  
across Mounting Tabs  
(for appearance only)  
Place Level  
across Mounting Tabs  
(for appearance only)  
Power Stealing Switches  
The Power Stealing Switches (Fig. 1) should be left in the  
"On" position for most systems. The information in the  
following table details the thermostat power method and  
switch options.  
Rear view of thermostat  
2 "AA" Batteries  
Power  
Stealing  
Switches  
Stack  
Power  
Stealing  
Switch  
2
GeneralDetails
NameOH-1202H Universal Humidity Touchscreen Thermostat Instruction Manual
MakeOH
LanguageEnglish
FiletypePDF (Download)
File size0.42 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

OH-1202H Universal Humidity Touchscreen Thermostat Instruction Manual