Home > uponor > uponor D Plus RH T-247 BUS Smatrix Base Thermostat Instruction Manual

uponor D Plus RH T-247 BUS Smatrix Base Thermostat Instruction Manual

4 Operation  
Thermostat key descriptions  
4.1 Thermostat operation  
C
A
B
CD0000800  
Item  
A
Key/icon  
Description  
Minus/decrease  
OK  
-
B
O
+
C
Plus/increase  
CD0000787  
- and + keys  
The keys and + are used to  
Power on/reset display  
Activate the thermostat  
Adjust setpoint temperature  
Move from one parameter to the next/previous one in the  
settings menu  
O (OK) key  
The key O (OK) is used to  
CD0000778  
Activate the thermostat  
Toggle between current status data, and values of available  
sensors connected to the thermostat  
The software version is displayed for 3 seconds after power on, or  
performing a factory reset (followed by a restart), after which it will  
swtich to the main screen. The LEDs will remian on for 20 seconds,  
and if there is no activity (no button is pressed), they will  
automatically turn off.  
Enter and exit the settings menu (holding the key for about  
3 seconds)  
Confirm a setting  
When a button is pressed, the main screen reappears, and the LEDs  
light up again. If there is no further activity, the LEDs will turn off  
again after 20 seconds.  
4.2 Display descriptions  
U
T
S
R
Register thermostat to the room  
controller  
A
B
C
Q
P
O
D
E
N
M
F
G
H
I
J
K
L
CD0000785  
CD0000786  
After the Smatrix controller is set to registration mode and the  
required channels are selected, proceed to the thermostat and press  
the + and - buttons for 5 seconds to initiate the registration process.  
Symbols/icons  
The figure shows all possible symbols and characters that can be  
shown on the display:  
The screen will display "CnF" and the icon (  
) will flash, indicating  
that the registration is in progress. After successful registration, the  
Item  
Icon  
Description  
A
Alarm  
icon (  
) will remain steady, and the screen will switch to run mode,  
displaying the main screen.  
If the registration process is not completed successfully within the 20-  
seconds timeout period, the thermostat will display the "not paired"  
B
Relative humidity measured with  
the RH sensor  
icon (  
). After a few seconds, it will return to run mode, displaying  
the main screen.  
|
|
6
Uponor Smatrix Base thermostat D+RH T-247 BUS Operation manual  
GeneralDetails
Nameuponor D Plus RH T-247 BUS Smatrix Base Thermostat Instruction Manual
Makeuponor
LanguageEnglish
FiletypePDF (Download)
File size0.4 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
Uponor T-247 BUS Smatrix Base Thermostat Installation Guide
Uponor T-247 BUS Smatrix Base Thermostat Installation Guide
Uponor ETN4 Ecoflex Supra Standard Thermostat Instruction Manual
Uponor ETN4 Ecoflex Supra Standard Thermostat Instruction Manual

uponor D Plus RH T-247 BUS Smatrix Base Thermostat Instruction Manual