Home > MARS > mars 7602-457 Communicating Programmable Thermostat Instruction Manual

mars 7602-457 Communicating Programmable Thermostat Instruction Manual

Installation Manual - 7602-457 Communicating, Programmable Thermostat  
Comfort-Aire and Century's 7602-457 Communicating,  
Programmable Thermostat is the perfect compliment to a  
Comfort-Aire and Century's Geothermal Heat Pump System  
and represents a significant advancement in thermostat  
communicating technology. For homeowners, the 7602-457  
provides highly customizable climate control features  
designed to maximize comfort and reduce the amount of  
energy consumed by the Comfort-Aire or Century  
a time. Be careful not to allow wires to fall back  
into the wall.  
C. As each wire is disconnected, record wire color  
and terminal marking.  
D. Discard or recycle old thermostat.  
NOTE: Mercury is a hazardous waste and MUST be dis-  
posed of properly.  
Geothermal Heat Pump System. For dealers, it represents  
a significant, industry leading advancement in configuration,  
monitoring and diagnostics from the thermostat. Please read  
the following instructions carefully to maximize the comfort  
and cost-saving potential of your Comfort-Aire or Century  
Geothermal Heat Pump System.  
3. Separate the thermostat from base.  
4. Route thermostat wires through hole in base. Level  
base against wall (for aesthetic value only - thermo-  
stat need not be leveled for proper operation) and  
mark wall through 2 mounting holes.  
5. Drill two 3/16-in. mounting holes in wall where  
marked. (Note: Mounting holes on thermostat are  
designed to t on a horizontal J-box).  
6. Secure base to wall with 2 anchors and screws  
provided making sure all wires extend through hole in  
base.  
SAFETY CONSIDERATIONS  
7. Connect wires to proper terminal of the connector  
block in the thermostat.  
Improper wiring or installation may damage thermostat. Wir-  
ing must conform to local and national electrical codes  
8. Push any excess wire back into wall. Excess wire  
inside the thermostat case can interfere with proper  
air ow across the temperature sensor. Seal hole in  
wall to prevent air leaks. Leaks can affect operation.  
9. Install thermostat on base.  
ѥꢀWARNING! ѥ  
WARNING! Before installing thermostat, turn off all  
power to unit. There may be more than one power  
disconnect. Electrical shock can cause personal  
injury or death.  
10. Turn on power to the unit.  
III. WIRING DIAGRAMS  
All excess wire should be pushed back into the wall as far as  
possible. Excess wire inside the thermostat plastic case may  
interfere with the air ow across the temperature sensor.  
INSTALLATION CONSIDERATIONS  
The thermostat requires no batteries. The thermostat is not  
a power stealing device and MUST have both R and C termi-  
nals connected. See Diagram 1.  
Diagram 1: Thermostat Connections  
DXM2  
Control  
INSTALLATION  
I. THERMOSTAT LOCATION  
Thermostat should be mounted:  
7602-457 Thermostat  
Gnd  
C
R
Approximately 5 ft. (1.5m) above oor.  
Close to or in a frequently used room, preferably on an  
inside partitioning wall.  
B-  
A+  
A+  
B-  
24V  
On a section of wall without pipes or duct work.  
Thermostat should NOT be mounted:  
Outdoor  
Sensor  
(Optional)  
OD  
Close to a window, on an outside wall, or next to a  
door leading to the outside.  
Exposed to direct light and heat from a lamp, sun,  
replace, or other temperature-radiating object which  
may cause a false reading.  
GND  
Remote Indoor  
Sensor  
(Optional)  
ID  
Thermostat Connections  
C
R
A+  
B –  
GND Ground  
OD  
ID  
Close to or in direct airow from supply registers.  
In areas with poor air circulation, such as behind a  
door or in an alcove.  
24V Common for Control Circuit  
24V Supply for Control Circuit  
Communications (Positive)  
Communications (Negative)  
II. THERMOSTAT INSTALLATION  
1. Turn off all power to unit.  
Outdoor Temperature Sensor  
Indoor Temperature Sensor  
2. If an existing thermostat is being replaced:  
A. Remove existing thermostat from wall.  
B. Disconnect wires from existing thermostat, one at  
3
GeneralDetails
Namemars 7602-457 Communicating Programmable Thermostat Instruction Manual
MakeMARS
LanguageEnglish
FiletypePDF (Download)
File size0.49 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

mars 7602-457 Communicating Programmable Thermostat Instruction Manual