Home > IDEAL > Ideal 229177 Halo Heat and System 2 Zone Extension Thermostat User Guide

Ideal 229177 Halo Heat and System 2 Zone Extension Thermostat User Guide

TROUBLE SHOOTING  
1. HALO NOT COMMUNICATING WITH HALO  
SMART INTERFACE  
2. SMART WIRING CENTRE NOT COMMUNICATING  
WITH SMART INTERFACE  
If the below message shows on the Halo screen  
then it is not communicating with the Halo Smart  
Interface.  
If the below message shows on the Halo screen then  
the Smart Wiring Centre is not communicating with  
the Smart Interface.  
Please follow the on screen recommendations  
additionally for further help you can visit  
idealheating.com  
Please follow the on screen recommendations,  
additionally for further help you can also visit  
idealheating.com  
During this fault condition your heating zone valves  
will need to be manually operated via the buttons on  
the Smart Wiring Centre. When communication is  
restored this override mode is disabled.  
Please note even without a signal between the  
Halo and the Halo Smart Interface the heating will  
continue to operate in Failsafe mode. In Failsafe mode  
the schedule will still operate however the output  
temperature of the boiler will be reduced.  
You can also manually switch your boiler On and Off  
by using Override button on the Smart Interface.  
When the Override is pressed it will disable failsafe  
mode and allow full manual control of the boiler until  
the connection is restored. When communication  
is restored both Failsafe and Override modes are  
disabled.  
GeneralDetails
NameIdeal 229177 Halo Heat and System 2 Zone Extension Thermostat User Guide
MakeIDEAL
LanguageEnglish
FiletypePDF (Download)
File size0.83 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

Ideal 229177 Halo Heat and System 2 Zone Extension Thermostat User Guide