Home > seitron > seitron TR D02B Wireless Digital Thermostat User Manual

seitron TR D02B Wireless Digital Thermostat User Manual

INSTALLATION  
Find the best location for the installation (see section  
‘RADIO SYSTEM CONFIGURATION), then secure the  
thermostat base to the wall using the two screw holes with  
a 60mm. distance (use the screws and/or bolts supplied)  
after having passed the remote sensor wires (if present)  
through the rectangular opening (A in Fig. 5).  
Close the thermostat as follows:  
3
5
-
Match the two teeth located in the right side of the  
plastic base with the two slots located on the plastic  
cover.  
a
WARNING  
-
Make sure that the transmitted radio signals are  
correctly received by the receiving unit before installing  
the thermostat.  
-
Close the left side of the cover while slightly pressing  
with a finger, at the same time, the plastic tooth on the  
left side to the internal (see the arrow in Fig. 8).  
Complete the rotation of the cover until the plastic tooth  
on the base snaps into the relevant hole of the cover.  
-
Install the thermostat at about 1.5 m from the floor,  
away from heat sources, draught and particularly cold  
walls (heat bridges), for the room temperature to be  
regulated correctly. These notes must be applied to  
place the remote sensor when this is used to acquire  
the room temperature.  
m
m
0
6
-
-
A remote sensor must be connected using wires having  
at least 1.5 mm² section and no longer than  
15  
metres. Do not use the same pipes for sensor signals  
and mains voltage.  
The installation and electrical connection of the  
thermostat must be performed by qualified personnel  
and in compliance with current standards.  
A
1
Push, with the help of a screwdriver, the plastic tooth  
located in the slot on the left side, then lift the plastic  
cover (Fig. 3).  
1
Fig. 5  
3
1
-
Insert the batteries (respecting the correct polarity) in  
the battery compartment (C in Fig. 6); use only alkaline,  
brand new batteries.  
4
-
Connect the remot sensor (if present) using the  
‘REMOTE SENSOR’ connector (B in Fig. 6), according  
to the wiring diagram shown in Fig. 7; then remember to  
set properly the parameter P10.  
2
Fig. 8  
Read the section 'INSTALLER CONFIGURATION'.  
Configure the thermostat: see "INSTALLER  
CONFIGURATION" paragraph.  
6
Fig. 3  
Turn the cover, while pressing it slightly, until it is fully  
2
extracted (Fig. 4).  
B
C
Fig. 4  
Fig. 6  
Fig. 7  
Table 1: Installer configuration  
Summary of the configuration parameters.  
CON  
trA  
P01  
P02  
Heating/Cooling selection  
trA Transmitter  
rEC  
rO  
r
Receiver  
Comfort -  
CrO  
Economy -  
Off  
CrO  
Allowed regulation modes setting  
C O Comfort - Off  
O
Off  
Economy - Off  
Comfort -  
Cr  
Economy  
C
Comfort  
Economy  
6.0  
0.0  
P03  
P04  
P05  
P06  
P07  
P08  
P09  
Antifrost temperature set-point (°C)  
OFFSET: Room temperature correction (°C)  
Sampling time (minutes)  
no | 0.5 .. 25.0  
-10.0 .. +10.0  
3 | 10  
10  
8.0  
Temperature Set-point lower limite heating (°C)  
Temperature Set-point upper limit heating (°C)  
Temperature Set-point lower limite cooling (°C)  
Temperature Set-point upper limit cooling (°C)  
5.0 .. 35.0  
5.0 .. 35.0  
5.0 .. 35.0  
5.0 .. 35.0  
29.0  
10.0  
35.0  
Internal NTC  
sensor  
Remote NTC  
sensor  
Int  
no  
no  
P10  
P11  
P12  
NTC sensor configuration  
Int  
Ext  
PWM Regulation of receiver output  
no  
no  
ON/OFF  
YES  
YES  
PWM  
Extends setting of P11, P13, P14, P15, P16 and P17  
parameters to all connected receiver channels (DLP--- series)  
Not active  
Active  
0.2  
2.0  
60  
30  
3
P13  
P14  
P15  
P16  
P17  
P18  
End  
Hysteresis (°C)  
0.1 .. 5.0  
PWM Proportional band (°C)  
1.0 .. 8.0  
0 .. 180  
15 .. 60  
0 .. 15  
Additional time (minutes)  
Duration of each PWM cycle (minutes)  
PWM output switch-on minimum duration (minutes)  
Default display of the set-point temperature  
no  
no  
Ta. disp  
YES set-point disp OnL Vis. set–point only  
TRD02B0000SE 039165 050422  
3
- ENGLISH -  
GeneralDetails
Nameseitron TR D02B Wireless Digital Thermostat User Manual
Makeseitron
LanguageEnglish
FiletypePDF (Download)
File size1.82 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
seitron Wi-Time Wall Wi-Fi Programmable Thermostat Instruction Manual
seitron Wi-Time Wall Wi-Fi Programmable Thermostat Instruction Manual
seitron TAD022 Digital Room Thermostat for Heating Cooling System Instruction Manual
seitron TAD022 Digital Room Thermostat for Heating Cooling System Instruction Manual
seitron TM 00-M Electro Mechanical Room Thermostat Instructions
seitron TM 00-M Electro Mechanical Room Thermostat Instructions
seitron 039790 WiFi WiTime Wall Programmable Thermostat User Guide
seitron 039790 WiFi WiTime Wall Programmable Thermostat User Guide
seitron DR R02M Thermostat Wireless Kit Instruction Manual
seitron DR R02M Thermostat Wireless Kit Instruction Manual
seitron KTY003 Hygge Kit Class 5 WiFi Battery Powered Programmable Thermostat User Guide
seitron KTY003 Hygge Kit Class 5 WiFi Battery Powered Programmable Thermostat User Guide

seitron TR D02B Wireless Digital Thermostat User Manual