7. Run Power To The Gateway(Use The Power Adaptor Supplied To Connect The Gateway → All Cables Must Be Supported → The Power Adaptor And Wiring Must Not Be Inside The Appliance → The Power Adaptor Must Be Supported)
8. Installation Of 230v Switched Connection(Connect The System Control Wiring To The Gateway → Gateway Terminals - On/off → Gateway Terminals - Ot → Gateway Terminals - R-bus)
9. Installation Of Opentherm Connections(To Connect Using The Ot Terminals → Do Not Connect 230v To These Opentherm Terminals Or It Will Damage The Gateway → V Power Supply → Room Unit → Ot Controlled Boiler → Opentherm Controlled Appliance)
11. Slacken(Make Sure The Wires Are As Flat As Possible → Press The Room Unit Onto The Backplate Until It Clicks Into Place → Connect The Other End Of The Wires To The R-bus Terminals In The Gateway → The Connection Between The Room Unit And Gateway Is Low Voltage)
12. Set Up The Usense 2 Room Unit(Before Turning On The Power To The Gateway, Room Unit And Heating System → Download The Baxi Thermostat App And Create A Usense Account)
13. Opentherm Hot Water Control(The Usense 2 Room Unit Will Override The Hot Water Temperature Controls → Default Hot Water Temperature → Default Heating Flow Temperature → Adjusting Settings With Usense 2)
14. Outdoor Sensor(Connecting To An Outdoor Sensor → Adjusting The Heating Curve)
15. Technical Specifications(Usense 2 Room Unit → Dimensions → Power Supply → Ambient Conditions → Operating Conditions)
16. Usense 2 Room Unit(Technical Data → Room Temperature Measurement Range → Maximum Temperature Deviation At 20 C → Maximum Room Control Overshoot → Temperature Variation → Outside Temperature)
17. Compliant With Standards(Drop Test → Protection Classification → Erp Fiche Information → Contribution To Space Heating Energy Efficiency)
Loading...
