Honeywell TH6320ZW2003 Pro Z-Wave Programmable Thermostat Installation Guide
Wiring UWP
Push down on the tabs to put the wires into the inner
holes of their corresponding terminals on the UWP (one
wire per terminal) until they are firmly in place. Gently
tug on the wires to verify they are secure. If you need to
release the wires again, push down the terminal tabs on
the sides of the UWP.
Setting Slider Tabs
Set R Slider Tab.
This wiring is just an example,
yours may vary.
• Use built-in jumper (R Slider Tab) to
differentiate between one or two transformer
systems.
UWP Mounting System
• If there is only one R wire, and it is connected
to the R, Rc, or RH terminal, set the slider to
the up position (1 wire).
• If there is one wire connected to the R
terminal and one wire connected to the Rc
terminal, set the slider to the down position (2
wires).
NOTE: Slider Tabs for U terminals should be left
in place for other thermostat models.
R/Rc slider tab
Wiring terminal designations
L/A
- A
Heat Pump fault input
(C wire required)
Input for wired
indoor or outdoor
sensors
S
S
Y
O/B
Changeover valve
Compressor
contactor (stage 1)
AUX - Auxiliary heat relay
W2
Heat relay (stage 2)
Compressor
contactor (stage 2)
Y2
G
E
Emergency Heat relay
Heat relay (stage 1)
Fan Relay
W
Note: Not all
terminals may be
used, depending
on the system
type that is being
wired. The most
commonly used
terminals are
24 VAC common.
For 2 transformer
systems, use
common wire from
cooling transformer.
Connect to K on C-wire
adapter**
C
K
24 VAC power from
heating transformer*
U
U
R
Unused
24 VAC power from
cooling transformer*
shaded.
Rc
* Terminal can be jumped using Slider Tab. See “Setting Slider Tabs” above.
** The THP9045A1098 C-wire adapter is used on heat/cool systems when you
only have four wires at the thermostat and you need a fifth wire for a common
wire. Use the K terminal in place of the Y and G terminals on conventional or
heat pump systems to provide control of the fan and the compressor through
a single wire—the unused wire then becomes your common wire. See THP9045
instructions for more information.
5
| General | Details |
|---|---|
| Name | Honeywell TH6320ZW2003 Pro Z-Wave Programmable Thermostat Installation Guide |
| Make | Honeywell |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.34 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Honeywell T6 Pro Programmable Thermostat User Manual
Honeywell D1-528 Direct Thermostat Installation Guide
Honeywell FocusPRO P200 Programmable Thermostat User Guide
Honeywell RCHT8610WF Series Smart Thermostat Installation Guide
Honeywell T9 Smart Thermostat Installation Guide
Honeywell TH2320WF4011 FocusPRO Smart S200 Series Thermostat User Guide
Honeywell TL116A Thermostat Installation Guide
T10 Pro Smart Thermostat with Redlink Room Sensor
Honeywell TH6320WF2003 Lyric T6 Pro Wi-Fi Programmable Thermostat User Guide
Honeywell RTH9580 Wi-Fi Color Touchscreen Programmable Thermostat User Guide
ESi Controls ESRTP4TOUCH Programmable Room Thermostat Instruction Manual
nVent RAYCHEM SENZ Wifi Programmable Floor Heating Thermostat User Guide
Danfoss Link Connect Thermostat User Guide
Danfoss CAS 178 Thermostat Installation Guide
EBECO EB-25 Regulator Thermostat Instruction Manual
PYMETER PY-23T PID Dimming Thermostat Instruction Manual
Moes BHT-006 Series Thermostat User Manual
Uponor ETN4 Ecoflex Supra Standard Thermostat Instruction Manual
ENGO CONTROLS EONEBATW, EONEBATB Internet Controlled Thermostat User Manual
Danfoss RT 107 Series Thermostat Installation Guide