Home > Emerson > EMERSON Programmable Touchscreen Thermostat Setup in E2 and Site Supervisor User Guide
EMERSON Programmable Touchscreen Thermostat Setup in E2 and Site Supervisor User Guide
System Revision Display
IMPORTANT! If at least one of those parameters has been changed, the thermostat will reboot: Thermostat system configuration,
number of Heating stages or number of Cooling stages.
Prior to device restart, the display will show “- -” to indicate that the device is about to reboot. When the
device is rebooting, the display will turn off for approximately a few seconds until reboot operation has
completed.
Thermostat Display Before Reboot
E2
New Installation and Uploading of Touch_TStat Description File to E2
The Programmable Touchscreen Thermostat (P/N 810-1600) requires adding a description file (P/N 527-0729) to E2.
Contact Customer Service to obtain this information: Solutions.CustomerService@Emerson.com
NOTE: Ultrasite32
Software must be installed to perform a description file upload.
1. Connect to E2 using UltraSite32 (refer to the UltraSite32 Manual P/N 026-1002).
2. Launch the UltraSite program and log in.
3. Double-click to UltraSite to view Directory Level and Site Level.
4. Right-click on Site Level and click Connect.
5. Double-click on Site Level and locate the E2 Unit where the Touch T-Stat.dsc will be installed.
6. Right-click on the unit and select Upload Description File.
7. Click Browse and select the appropriate description (*.dsc) file for Touch T-Stat.dsc from the
computer and click Open.
8. Click Upload. A window will display that the description file was successfully imported. Click OK.
The description (*dsc) file should appear in the list.
9. Once completed, disconnect from the E2 and reboot the E2 controller - either manually with the
toggle switch or remotely through Terminal Mode.
NOTE: DO NOT omit the step of rebooting the controller.
Document Part # 026-4850 Rev 1
Page 7 of 10
©2020 Emerson Retail Solutions, Inc. This document may be photocopied for personal use.
| General | Details |
|---|---|
| Name | EMERSON Programmable Touchscreen Thermostat Setup in E2 and Site Supervisor User Guide |
| Make | Emerson |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.23 MB |
(1 votes, average: 5.00 out of 5)
Loading...
EMERSON ST75W Sensi Touch Wi-Fi Smart Thermostat Installation Guide
EMERSON Thermostat Common Wire Kit SA11 Instruction Manual
EMERSON 1F75H-21PR Programmable Heat Pump Thermostat Instruction Manual
EMERSON 1F75C-11PR Programmable Thermostat Installation Guide
EMERSON 1D56-310 White-Rodgers Low Voltage Horizontal Mounting Thermostat Instruction Manual
EMERSON 1F76U-22WFB Series Sensi Lite Smart Thermostat Installation Guide
EMERSON 1F87U-42WF Sensi Smart Thermostat User Guide
EMERSON 1F83C-11NP Single Stage Thermostat Owner’s Manual
EMERSON 1F75P-21PR Display Thermostat Instruction Manual
EMERSON 1F75H-21NP Non Programmable Heat Pump Thermostat Instruction Manual
MRCOOL 16117100003415 Versa Pro Wired Thermostat Owner’s Manual
Honeywell TH2320WF4011 FocusPRO Smart S200 Series Thermostat User Guide
Amana DS01G Digi Smart Thermostat Instruction Manual
Honeywell Home S200 Series FocusPRO Smart Thermostat User Guide
Puravent CFST Frost Thermostat Installation Guide
WTE WT-100 Zigbee Thermostat User Manual
Honeywell T827 Series Heat Only Vertical Thermostat Owner’s Manual
DEVIreg Electronic Intelligent Timer Thermostat Installation Guide
GENERAL HT300S Smart Room Thermostat User Manual
LuxPro PSPLV512d Programmable Heating Thermostat Instruction Manual