meitav-tec FMH24-PD-1S-IR Thermostat Owner’s Manual

1

2

All manuals and user guides at all-guides.com  

Meitav-tec Ltd (Contel group)  

Tel: 972-3-9626462 Fax: 972-3-9626620  

www.meitavtec.com - support@meitavtec.com  

FMH24-PD-1S-IR  

Owner's Manual - Installation and Operating Instructions  

Please read this manual carefully before installation and use.  

Index  

Installation Instructions  

Wiring Connections  

Operating Manual  

1

2

3

1. Installation Instructions  

Is very important to find the right place to install the Flush Mount unit.  

Please make sure to follow all the installation instructions in order to get an  

accurate reading of the temperature.  

General points to follow:  

•

•

•

•

The unit MUST be fitted into a standard electrical box (Gewiss Box - GW00001481VR)  

The unit should not be installed on an outside wall or where there is an air draft.  

The unit must not be exposed to a direct sunlight.  

The standard height to install this unit is 1.5 meter from the floor (5 feet).  

Installation procedure:  

Connect the wires (see #2)  

Put the thermostat in the electrical box.  

- 1 -  

File: fmh24-pd-1s-A4-rev1.doc  

Rev. 1 Date:07/06/2005  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	meitav-tec FMH24-PD-1S-IR Thermostat Owner’s Manual
Make	meitav-tec
Language	English
Filetype	PDF (Download)
File size	0.1 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL THERMOSTAT INSTRUCTIONS & USER MANUALS
• meitav-tec

meitav-tec FMH24-PD-1S-IR Thermostat Owner’s Manual Overview

Summary of Contents

• Page 1: Owner's manual - installation and operating instructions Please read this manual carefully before installation and use. Installation instructions It is very important to find the right place to install the flush mount unit. Please make sure to follow all the installation instructions in order to get an accurate reading of the temperature. The unit must be fitted into a standard electrical box. The unit should not be installed on an outside wall or where there is an air draft. The unit must not be exposed to direct sunlight. The standard height to install this unit is 1.5 meters from the floor. Installation procedure: connect the wires and put the thermostat in the electrical box.
• Page 2: Tighten up the 2 screws. Adapt the front frame-panel into its place, by pushing it towards the wall. Wiring connections. Switch function. Press the ON button to activate the thermostat. ON will appear on display. Press the OFF button to deactivate the thermostat. OFF will appear on display. Press the (+) or (-) to change the set temperature. Press the MODE button to switch between cool, heat, and fan only.