EcoNet RETST800SYS Smart Thermostat User Guide
Settings (con’t)
Settings
Basic
Time
Humidity
Fan
Humidity Settings (Menu > Settings > Humidity)
Control your home’s humidity settings for more ideal comfort.
Away
Vacation
BACK
Installer
Dehumidification
Enable Dehumidification?
Yes
Dehumidify Set Point
Over-Cooling Amount
Dehumidify Drain Timer
52 %
0 ºF
Dehumidification (Menu > Settings > Humidity)
5 min.
Enable Dehumidification – The system will attempt to reduce humidity
in cooling mode by reducing fan speed and over-cooling the space (when
allowed by the Over-Cooling setting). The system will only reduce airflow if
the room temperature is within one degree of set point, otherwise, full cooling
airflow will be performed.
HUMIDIFICATION
BACK
Dehumidify Set Point – The indoor relative humidity to be controlled to while
in cooling mode.
Over-Cooling Amount – The system will activate cooling, and possibly over-
cool the space by the desired number of degrees to improve dehumidification
performance in an effort to reach the dehumidify set point. The factory setting
for over-cooling is zero (no over-cooling) and can be adjusted up to 5 degrees
of over-cooling.
Dehumidify Drain Timer – At the end of a cooling cycle, if set, the continuous
fan setting will be turned off for the selected amount of time in order to drain
water from the indoor coil.
Humidification
Enable Humidification?
No
30 %
Humidify Set Point
Humidify During...
Heat
Off
Humidification (Menu > Settings > Humidity > Humidification)
Smart Control
Humidity With Fan
Off
Enable Humidification – The system can control a humidifier attached to the
furnace or air handler to increase humidity in the space. It is important to note
you cannot humidify above the dehumidification set point.
BACK
Humidification Set Point – This setting allows you to choose the indoor
relative humidity desired, under which humidification will activate. The default
is humidification set point is 30% and is configurable between 15 and 45%.
Humidify During – Select the modes in which humidification will be
performed. Humidification can occur during heating, continuous fan and/or
cooling mode.
• Heat – Humidifier will operate with equipment during Heat if a
humidification demand is present.
• Heat/Fan – Humidifier will operate with equipment during these modes if
a humidification demand is present.
• Heat/Fan/Cool – Humidifier will operate with equipment during these
modes if a humidification demand is present.
> Return to Table of Contents
EcoNet® Smart Thermostat User Guide 14
| General | Details |
|---|---|
| Name | EcoNet RETST800SYS Smart Thermostat User Guide |
| Make | EcoNet |
| Language | English |
| Filetype | PDF (Download) |
| File size | 6.45 MB |
(1 votes, average: 5.00 out of 5)
Loading...
EcoNet UETST800SYS Smart Thermostat User Guide
SALUS RT510 Thermostat Instruction Manual
ENSTO ECO16BTD Combination Thermostat Instruction Manual
SALUS CONTROLS RT200 Electronic Room Thermostat Instruction Manual
TRANE XR102 Non-Programmable Thermostat User Guide
GENERAL FH260S Underfloor Heating Thermostat User Manual
GENERAL SENNA 300 Smart Room Thermostat User Manual
HERSCHEL T-BT Battery Powered Wireless Thermostat Instruction Manual
GENERAL Life HT250 Wired Room Thermostat User Guide
EPH CONTROLS eTRV-HW Smart Cylinder Thermostat User Guide
AIRZONE IBPRO6 FLEXA 3.0 Blueface Zero Wired Thermostat User Manual