Satel ART-210 Wireless Radiator Thermostat Instruction Manual
SATEL
ART-210
3
union nut.
LED display.
knob.
LED display
Normally, the display is off. Touch the knob (Fig. 2) to turn on the display.
After turning on, the display shows temperature in degrees Celsius from the selected sensor
(Fig. 1). Symbols and messages are also shown on the display.
The display will be turned off after 20 seconds since your last activity using the knob.
Symbols on the display
temperature set for the Comfort temperature operating mode is displayed.
temperature set for the Economy temperature operating mode is displayed.
temperature / valve position set manually is displayed.
temperature from the sensor is displayed.
open window has been detected and the valve is closed.
Messages on the display
thermostat ready for calibration to be started. Press the knob to start the calibration.
thermostat adaptation in progress.
the knob is blocked. Press and hold the knob for 3 seconds to unblock it. The knob
can be unblocked if it has been blocked manually. If it has been blocked remotely,
it cannot be unblocked manually.
low batteries (battery voltage dropped below 2.3 V). Replace the batteries.
anti-freeze protection is enabled.
Boost Heat is enabled (number at the end is the number of minutes until the end of
the function). If you want to stop the Boost Heat, press and hold the knob for 3
seconds.
valve is closed. Press or turn the knob to open the valve.
| General | Details |
|---|---|
| Name | Satel ART-210 Wireless Radiator Thermostat Instruction Manual |
| Make | Satel |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.47 MB |

Satel ART-200 Wireless Radiator Thermostat Installation Guide





























