Home > marmony > marmony MTC-40 Radio Controlled Room Thermostat Instruction Manual

marmony MTC-40 Radio Controlled Room Thermostat Instruction Manual

INSTALLATION  
RECEIVER  
1. Connect the receiver to the 230 V socket which you intendto use to  
connect your marmony infrared heater.  
2. Connect the connector plug on your marmony infrared heater to the  
receiver socket.  
3. That’s it! In the factory settings, both the transmitter and the receiver  
are connected to each other (paired). The receiver now waits for  
commands from the transmitter / thermostat.  
Manual connection (pairing) of the transmitter and receiver:  
If you wish to connect an additional receiver to your radio-controlled  
thermostat or you wish to connect your receiver manually as a result of  
connection issues, proceed as follows...  
… Press the ON / OFF button on the receiver and the LED lights up green  
… The thermostat is in ON / OFF mode and the display lighting is on  
(short press on any button).  
… Press the “ - button” until “TEST” appears in the programme row of the  
display. Press „Start“. The display now switches the ON / OFF display in  
sync. Now press the ON / OFF button on the receiver for 3 seconds. The  
LED display flashes quickly for a short time, then the display appears  
in sync. The connection has now been established. Exit the connection  
mode by pressing the “ON / OFF” button on your thermostat. Your  
thermostat and receiver are now connected (paired).  
GeneralDetails
Namemarmony MTC-40 Radio Controlled Room Thermostat Instruction Manual
Makemarmony
LanguageEnglish
FiletypePDF (Download)
File size0.51 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

marmony MTC-40 Radio Controlled Room Thermostat Instruction Manual