Home > DOIT > Doit 474053 Low Voltage Thermostat Installation Guide

Doit 474053 Low Voltage Thermostat Installation Guide

• unheatedareasbehindthethermostat, suchasanoutsidewall.  
ROUTE WIRES TO LOCATION  
1. If you are replacing an old thermostat and the wiring and  
location are satisfactory, use existing wiring. If in doubt, rewire.  
2. If you choose a new location or if this is a new installation,  
thermostat wire must first be run to the selected location. All  
wiring must conform to local and national electrical codes and  
ordinances.  
3. Probe for obstructions in partition before drilling 12” hole in wall  
at selected location. Take up quarter round (if necessary) and  
drill a small guide hole for sighting (see fig. 1). From basement,  
3
drill a 4” hole in partition floor next to guide hole. In houses  
without basements, drill 12” hole through ceiling and into parti-  
tion from above.  
8
1
⁄ ” hole for  
2
thermostat wire  
Stout cord with 6”  
chain attached  
Approximately  
5 feet from floor  
Baseboard  
strip moulding  
1
⁄ ” guide hole  
4
for sighting  
Quarter round  
removed  
3
⁄ ” hole in floor of partition  
4
Hooked wire for snagging chain  
Figure 1. Routing thermostat wires  
9
GeneralDetails
NameDoit 474053 Low Voltage Thermostat Installation Guide
MakeDOIT
LanguageEnglish
FiletypePDF (Download)
File size0.12 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

Doit 474053 Low Voltage Thermostat Installation Guide