Home > KINGHOME > KINGHOME WK-010WD1 Smart Thermostat Owner’s Manual

KINGHOME WK-010WD1 Smart Thermostat Owner’s Manual

Thermostat  
3.2 Wiring Instructions  
3.2.1 Wire Selection  
Cord length L(feet)  
Cord size (mm2/AWG)  
L164  
2×0.3mm2~2×0.8mm2 (2×AWG22~2×AWG18)  
Attention  
(1) The communication cords must use light/ordinary polyvinyl chloride  
sheathed cords. If the thermostat is installed in a place with strong  
electromagnetic interference, communication cords of thermostat must  
use shielded cords.  
(2) The cords of the thermostat must be selected according to the  
requirements of this manual, and it is strictly prohibited to choose the  
communication cords that does not meet the requirements of this manual.  
(3) It's recommended that the length of communication cords should be 8m.  
(4) It's recommended to use AWG18 cords as power cords.  
3.2.2 Wiring Ports  
Port printing  
Meaning  
H1, H2  
Communication port of thermostat  
RS485  
C, R  
Power port  
24VAC  
Port parameter  
3.3 Installation Steps  
Figure 3.3 Installation Diagram  
Please use the following steps to complete installation:  
(1) Cut off the power supply by using the master switch or circuit breaker box.  
The power must be cut off during the whole installation process for your  
safety.  
(2) During installation, be careful not to damage to touch screen.  
(3) In step  
, fix the rear cover of electric box on the wall with 2 screws.  
3
GeneralDetails
NameKINGHOME WK-010WD1 Smart Thermostat Owner’s Manual
MakeKINGHOME
LanguageEnglish
FiletypePDF (Download)
File size0.35 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
KINGHOME WK-010WC1 Smart Thermostat Owner’s Manual
KINGHOME WK-010WC1 Smart Thermostat Owner’s Manual

KINGHOME WK-010WD1 Smart Thermostat Owner’s Manual