Home > TIME O STAT > TIME O STAT 2 Channel 3 Wired HMO Thermostat Installation Guide

TIME O STAT 2 Channel 3 Wired HMO Thermostat Installation Guide

3. Configuring your Time:o:stat  
The Time:o:stat is shipped with the default advanced settings  
and locking bitswitch disabled. It is recommended that the  
locking bitswitch is enabled following changes to the  
advanced settings. This helps prevent tenants tampering with  
the advanced settings.  
To adjust the advanced settings:  
1. Press and hold the button (A) and button (C) then button  
(T) for around 3 seconds  
2. Setup 1 screen (For selecting countdown duration) will  
then be displayed (see the screen below)  
3. In the top right of the screen the advanced setting option  
being selected is displayed. (in this case 2hr countdown)  
Below is the flow of setup screens for the advanced settings.  
The table shows the options for each advanced setting. The  
default setting is in bold. To change the advanced setting,  
cycle the options using the + and buttons (C) and (D). To  
move to the next setup screen, press the (T) button below  
the screen.  
Screen  
Setup 1  
Setup 2  
Setup 3  
Setup 4  
Setup 5  
Setup 6  
Setup 7  
Setup 8  
INFo  
Code  
dur  
ProG  
HIGH  
Low  
CoFt  
SEAS  
dEFt  
HW  
Advanced Setting  
Countdown Duration  
Auto-Program Duration  
Maximum Temperature  
Minimum Temperature  
Comfort Mode  
Options (default in bold)  
2hrs, 3hrs  
1hr, 2hrs, 3hrs, OFF  
o
o
2
8
C
,
2
3
C
14oC, 18oC, 19oC, 20oC, OFF, 7oC  
OFF, ON, Night  
Seasonal Mode  
OFF, ON  
Starting Temperature  
Hot Water (2-Channel)  
Signal Test / Info  
21oC, 23oC  
Prog (2x3hr durations), ON  
RF Signal Strength / Summary  
InFo  
GeneralDetails
NameTIME O STAT 2 Channel 3 Wired HMO Thermostat Installation Guide
MakeTIME O STAT
LanguageEnglish
FiletypePDF (Download)
File size0.17 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

TIME O STAT 2 Channel 3 Wired HMO Thermostat Installation Guide