Home > TIME O STAT > TIME O STAT 2 Channel 3 Wired HMO Thermostat Installation Guide

TIME O STAT 2 Channel 3 Wired HMO Thermostat Installation Guide

4. Repeat the same process to continue to set the YEAR and  
finally the TIME using the 24 hour clock format.  
When complete the Time:o:stat screen will be blank, with the  
time at the top.  
5. Changing the Wireless (RF) Channel  
Normally the radio frequency (RF) channel used for the  
communications between the Time:o:stat controller and  
receiver does not need to be changed. However you may be  
operating two Time:o:stats in close proximity. This could be  
due to Time:o:stats in adjacent properties or multiple  
boilers/zones within a property. To change the channel:  
1. Turn off the power to the boiler.  
2. Remove the both the Time:o:stat controller and receiver  
from the wall brackets.  
3. Adjust bitswitch settings 1.2.3.4 viewed through the  
aperture on the back of the receiver with a pin.  
4. Change the settings in the same aperture on the  
Time:o:stat master to match. (leave switch 5).  
5. Following any setting change you will need to RESET the  
control unit by holding the RIGHT side (+) and (-)  
buttons for 3 seconds. The info screen and signal  
strength meter will then display, press the (:t:) button  
to finish.  
6. Wireless Signal Strength Test  
1. Perform a RESET by holding the RIGHT side (+) and (-)  
buttons simultaneously for 3 seconds.  
2. This will show the advanced settings info screen and RF  
signal strength meter. It shows the current signal  
strength in bars at the bottom of the display.  
3. The signal strength indicator is dynamic, so you can  
move the unit around to find a location with stronger  
signal strength.  
GeneralDetails
NameTIME O STAT 2 Channel 3 Wired HMO Thermostat Installation Guide
MakeTIME O STAT
LanguageEnglish
FiletypePDF (Download)
File size0.17 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

TIME O STAT 2 Channel 3 Wired HMO Thermostat Installation Guide