Home > SIEMENS > SIEMENS TH192 HC Heating-Cooling Room Thermostat Instruction Manual

SIEMENS TH192 HC Heating-Cooling Room Thermostat Instruction Manual

Document No.129-076  
Installation Instructions  
March 14, 2022  
3. Moisten the needle and insert the test gauge and  
needle adapter in the test port (Figure 4). Read the  
control pressure.  
Troubleshooting  
Before troubleshooting the thermostat per Table 1, make  
certain there is clean dry supply air at 18 psi (124 kPa)  
minimum. Use the test probe gauge and needle adapter to  
measure the control pressure at the output pressure test  
port (Figure 4). The output pressure test port is accessible  
without removing the thermostat cover through the 8th  
opening from the top as follows:  
4. If the control pressure does not read 7 to 8 psi (48 to  
55 kPa), turn the calibration screw (Figure 3) using the  
calibration tool or a 1/8” (3.2 mm) wrench until the  
pressure is 7 to 8 psi (48 to 55 kPa). The sensing  
element is now in calibration and the set point can be  
changed to the desired room temperature.  
For TH192 HC thermostats, the port is on the left side.  
Heating Calibration  
CAUTION:  
If you use the wrong test port, thermostat  
damage can occur and result in  
replacement of the device.  
1. If not already done, remove the cover using the  
calibration tool. Verify that the room temperature is  
between 70 and 80F (21 and 27C).  
2. Verify that the supply pressure is 25 psi (172 kPa). Set  
the heating dial to the room temperature by turning the  
exposed adjustment knob or using a hex. Allow the  
thermostat to stand for about five minutes to adjust to  
the new setting.  
Table 1. Troubleshooting Guide.  
Problem  
Check  
Cause  
Action  
Control  
Air supply Low supply  
pressure  
As required  
pressure  
stays at  
approximately  
zero  
Nozzle or Dirt on nozzle or Clean nozzle  
or replace  
thermostat  
3. Moisten the needle and insert the test gauge and  
needle adapter in the test port (Figure 4). Read the  
control pressure.  
flapper  
flapper  
Restrictor Clogged  
restrictor  
Replace  
restrictor  
4. If the control pressure does not read 7 to 8 psi (48 to  
55 kPa), turn the calibration screw (Figure 3) using the  
calibration tool or a 1/8” (3.2 mm) wrench until the  
pressure is 7 to 8 psi (48 to 55 kPa). The sensing  
element is now in calibration and the set point can be  
changed to the desired room  
Calibration Out of calibration Recalibrate  
Control  
pressure  
stays at  
Nozzle  
Clogged nozzle Clean nozzle  
or replace  
thermostat  
approximately  
supply  
pressure  
Calibration Dirt on either  
supply or  
Alternately  
close and  
open nozzle  
by gently  
Reference  
exhaust valve  
seat  
Document  
Number  
pushing down  
the bimetal  
TH192-2, TH192 HC Heating/Cooling  
Room Thermostat Technical Instructions  
155-066P25  
Excessive air Supply and Connections are As required  
leakage from return line interchanged or  
exhaust port connection connection to  
TB 214, TH192 Adapter Kits Technical  
Bulletin  
155-231  
155-244  
on left side of  
thermostat  
port is incorrect  
TB 237, Accessories for Installation of  
TH192, TH193, or TH194 Room  
Thermostats Technical Bulletin  
Dimensions  
Figure 5. TH192 HC Dimensions in Inches (Millimeters).  
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models  
as design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners. ©  
2009-2022 Siemens Industry, Inc.  
Siemens Industry, Inc.  
Smart Infrastructure  
1000 Deerfield Parkway  
Buffalo Grove, IL 60089-4513  
USA  
Your feedback is important to us. If you have  
comments about this document, please send them  
Document No. 129-076  
Printed in the USA  
Page 4 of 4  
Tel. +1 847-215-1000  
GeneralDetails
NameSIEMENS TH192 HC Heating-Cooling Room Thermostat Instruction Manual
MakeSIEMENS
LanguageEnglish
FiletypePDF (Download)
File size0.09 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
SIEMENS RDZ100ZB Zigbee Room Thermostat Owner’s Manual
SIEMENS RDZ100ZB Zigbee Room Thermostat Owner’s Manual
SIEMENS RDG400 Room Thermostat Instruction Manual
SIEMENS RDG400 Room Thermostat Instruction Manual
SIEMENS M3182 Room Thermostat Instruction Manual
SIEMENS M3182 Room Thermostat Instruction Manual
SIEMENS RDS120-B Smart Thermostat Instructions
SIEMENS RDS120-B Smart Thermostat Instructions
SIEMENS Powers Controls TH 192-3 Series Day Night Vent Room Thermostat Instruction Manual
SIEMENS Powers Controls TH 192-3 Series Day Night Vent Room Thermostat Instruction Manual
SIEMENS RDY2000BN BACnet Commercial Thermostat User Manual
SIEMENS RDY2000BN BACnet Commercial Thermostat User Manual
SIEMENS RDH100RF/SET Room Thermostat Instruction Manual
SIEMENS RDH100RF/SET Room Thermostat Instruction Manual
SIEMENS RDH100RF/SET Wireless Room Thermostat with LCD User Guide
SIEMENS RDH100RF/SET Wireless Room Thermostat with LCD User Guide
SIEMENS RS485 Flush Mounted Room Thermostat User Manual
SIEMENS RS485 Flush Mounted Room Thermostat User Manual
SIEMENS RDG260KN Room Thermostat Instruction Manual
SIEMENS RDG260KN Room Thermostat Instruction Manual

SIEMENS TH192 HC Heating-Cooling Room Thermostat Instruction Manual