Home > SALUS > SALUS RT310SR Wireless Thermostat User Manual

SALUS RT310SR Wireless Thermostat User Manual

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

2. Product Overview

The RT310 room thermostat simply switches the heating system on and oﬀ as necessary. It works by sensing the air temperature, switching on the heating

when the air temperature falls below the thermostat setting, and switching it oﬀ once this set temperature has been reached. Recommended for contro-

lling e.g. heating panels or electric heaters.

Turning a room thermostat to a higher setting will not make the room heat up any faster. How quickly the room heats up depends on the design of the

heating system, for example, the size of boiler and radiators. Neither does the setting aﬀect how quickly the room cools down. Turning a room thermostat

to a lower setting will result in the room being controlled at a lower temperature, and saves energy.

The heating system will not work if a time switch or programmer has switched it oﬀ.

The way to set and use your room thermostat is to ﬁnd the lowest temperature setting that you are comfortable with, and then leave it alone to do its

job. The best way to do this is to set the room thermostat to a low temperature – say 180C – and then turn it up by one degree each day until you are

comfortable with the temperature.

You won’t have to adjust the thermostat further. Any adjustment above this setting will waste energy and cost you more money.

If your heating system is a boiler with radiators, there will usually be only one room thermostat to control the whole house. But you can have diﬀerent

temperatures in individual rooms by installing thermostatic radiator valves (TRVs) on individual radiators. If you don’t have TRVs, you should choose a

temperature that is reasonable for the whole house. If you do have TRVs, you can choose a slightly higher setting to make sure that even the coldest room

is comfortable, then prevent any overheating in other rooms by adjusting the TRVs.

Room thermostats need a free ﬂow of air to sense the temperature, so they must not be covered by curtains or blocked by furniture. Nearby electric ﬁres,

televisions, wall or table lamps may prevent the thermostat from working properly.

Product advantages:

•

set factory-paired and ready to work

has a TPI control algorithm

automatically repeats the signal

has a frost protection mode (temperature range 5 - 17 degrees)

correction of the displayed temperature 3ºC

has a HOLIDAY mode and SLEEP mode (suspending the function, e.g. outside the heating season)

has unique transmission codes

operates at 868 MHz - a stable and noise-resistant signal

2.1 Package content

1) RT310TX thermostat

2) SR868 smart relay receiver

2) 2x AA batteries

3) Short instruction

4) Mounting screws

2.2 Proper thermostat location

Please note:

The ideal position to thermostat mounting is about 1,5m under ﬂoor level far from heating or cooling sources. Thermostat can’t be

exposed to sunlight or any extreme conditions like for example draft.

Because of ﬁre and explosion risk there is not allowed to use thermostat in atmosphere of explosive gases and ﬂammable liquids (eg coal dust). In case

if any of listed dangers occur you have to use additional protection measures – anti-dust and explosive gases (tight cover) or prevent their formation.

Furthermore, thermostat can’t be used in condensation of water vapor conditions and be exposed to water action.