SALUS RT310RF Digital Wireless Central Heating Room Thermostat User Manual
Test Pairing Function
Make sure your devices are wired and the thermostat has batteries inserted. Switch receiver to ON. If you are
using the RT310RF pack, the pairing between the thermostat and the receiver is already done. If you bought
the RT310TX and RXRT510 separately then pair as follows. Please make sure that the Receiver is set on Auto.
Note: Before beginning the process, switch the receiver On/Off and then On again to reset it (On/Off/On).
ON
OFF
ON
OFF
ON
OFF
AUTO
MANUAL
AUTO
MANUAL
AUTO
MANUAL
Begin the pairing process
End the pairing process
TESTING/PAIRING
TESTING/PAIRING
TESTING/PAIRING
TESTING/PAIRING
3 Sec
3 Sec
Wait 9 minutes for the timeout
process to be complete.
Test the pairing process
ON
OFF
ON
OFF
AUTO
MANUAL
AUTO
MANUAL
TESTING/PAIRING
TESTING/PAIRING
Testing the RF transmissions
It is important to site both the Receiver and thermostat in locations where the RF signal cannot be interrupted.
The receiving range between the thermostat and Receiver is approximately 30 metres indoors, however many factors can
affect the RF transmission and shorten the operating distance, e.g. shielding by thick walls, foil back plasterboard, metal
objects such as filing cabinets, general RF interference, and so on. The range is generally large enough for most household
applications, but it is advisable to test the RF transmission from the intended thermostat location to the Receiver location
before fixing the thermostat to the wall.
To check the RF reception, follow the following steps:
1. Press the UP button on the thermostat until the set point temperature is higher than room temperature by a few
degrees.
2. Wait for a few seconds. The Heat on (heat call) indicator should appear on the bottom left of the LCD on the thermostat.
3. Check the green LED on the receiver unit - it should be lit.
4. Press the DOWN button to adjust the set point temperature to be lower than room temperature.
5. Wait for a few seconds, and the Heat on (heat call) indicator should disappear and the green LED should switch off.
6. If at step 3 the green LED is not illuminated, press the TEST/PAIRING button on the thermostat and try to place the
thermostat closer to the Receiver.
7. Repeat steps 1 to 5.
08 RT310RF Installation Manual
| General | Details |
|---|---|
| Name | SALUS RT310RF Digital Wireless Central Heating Room Thermostat User Manual |
| Make | SALUS |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.66 MB |
(1 votes, average: 5.00 out of 5)
Loading...
SALUS IT800 WIFI Smart Thermostat Installation Guide
SALUS 091FLRF Wireless Room Thermostat User Guide
SALUS Thermostat Sensor TS600 User Guide
SALUS Thermostat and Smart Plug Installation Guide
SALUS Programmable Wired Thermostat VS30W/VS30B Installation Guide
SALUS Wired Thermostat Installation Guide
SALUS Wired Digital Thermostat – Non-programmable HTRS230 User Manual
SALUS RT520 Radiator Thermostat User Guide
SALUS RT310 Thermostat User Manual
SALUS Thermostat RT520 User Manual
GE APPLIANCES RAK190V Energy Management Thermostat Owner’s Manual
Danfoss TP5001B Programmable Room Thermostat User Guide
COMPUTHERM E800RF Multizone Wi-Fi Thermostat Instruction Manual
INTIEL Controllers DT 3.1 Programmable Differential Thermostat User Guide
sinope TH1400NP Non Programmable Low Voltage Thermostat Installation Guide
Honeywell TC300 Commercial Thermostat Instruction Manual
tecnoswitch TE300ME Mechanical Thermostat User Guide
Honeywell T4098A Deluxe Electric Heat Thermostat Instruction Manual
EUROSTER 2026TXRX Air Conditioning Thermostat Instruction Manual
olympia electronics BS-850-KIT Wireless Programmable WiFi Electronic Chrono Thermostat User Manual