Home > Remotec > Remotec REMEZTRVV01 Z Wave Thermostat User Guide

Remotec REMEZTRVV01 Z Wave Thermostat User Guide

1

2

3

4

5

6

Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device is called association. In order to control a different

device, the controlling device needs to maintain a list of devices that will receive controlling commands. These lists are called association groups and they are

always related to certain events (e.g. button pressed, sensor triggers, ...). In case the event happens all devices stored in the respective association group will

receive the same wireless command wireless command, typically a 'Basic Set' Command.

Association Groups:

Group Number

Maximum Nodes

Description

Lifeline

Configuration Parameters

Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better to user needs or unlock further

enhanced features.

IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 ... 255 the value sent in the application shall be the

desired value minus 256. For example: To set a parameter to 200ꢀit may be needed to set a value of 200 minus 256 = minus 56. In case of a two byte value the

same logic applies: Values greater than 32768 may needed to be given as negative values too.

Parameter 1: Open window detect function

Size: 1 Byte, Default Value: 0

Setting

Description

Disable

Enable

Parameter 2: Anti-freezing function

Size: 1 Byte, Default Value: 0

Setting

Description

Disable