Home > Remotec > Remotec REMEZTRVV01 Z Wave Thermostat User Guide

Remotec REMEZTRVV01 Z Wave Thermostat User Guide

1

2

3

4

5

6

a. Choose the right adapter and install it to the valve if the TRV can not install to your valve directly.

Adapter:

Danfoss RA

Caleffi

Giacomini

Take off the batteries and put them on again to REPOWER the TRV

The screen will blink “LA” until it becomes solid

Install the TRV to the valve

Click the rotary plate once and the “LA” will start blinking again;

Installation completed (“LA” disappears and shows the temperature).

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the

devices of this network. This process is called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This

controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.

Inclusion

1. Power on your TRV,

2. Set your Z-Wave controller into add/inclusion mode.

3. In “OF” state, short press the rotary plate three times until the screen shows "--”.

4. The screen will show “PA” after few seconds, which meant the inclusion is successful. And the antenna icon will light on.

Exclusion

1. Power on your TRV

2. Set the Z-Wave primary controller into remove/exclusion mode.

3. In “OF” state, short press the rotary plate three times until the screen shows “--".

4. The screen will turn back to“OF” after few seconds, which meant the inclusion is successful. The antenna icon light will be off.