Home > olympia electronics > olympia electronics BS-850-KIT Wireless Programmable WiFi Electronic Chrono Thermostat User Manual
olympia electronics BS-850-KIT Wireless Programmable WiFi Electronic Chrono Thermostat User Manual
Installation procedure
The device shall be connected to an all-pole mains switch incorporated in the electrical
installation of the building
To install the devices BS-850/T or BS-851/T, insert a flat blade screwdriver in the slot as shown
in (Fig. 1). Press and lift the front cover.
Remove the retaining screws and remove the plastic cover that contains the keys (Fig. 2).
Use the supplied mount accessories to mount the unit according to the diagram of page 11.
Install the base, align it using the built in vial and tighten the screw to secure it.
Reinstall the plastic containing the keypad with care and fasten the screws with a maximum
torque of0,4 Nm.
To activate the device, remove the battery separation tape(Fig. 3).
Install the front cover with slight pressure and the device is ready to operate.
Fig. 1
Fig. 2
Fig. 3
To install the BS-851/R, remove the front cover with a screwdriver (Fig. 4).
Mark and drill the mounting holes according to the schematic in page 11.
Mount the device using the supplied mounting accessories (Holes Aand B)
as shown in Fig.5. Do the electrical connections according to (Fig.5).
Connect the phase to the Lterminal and the neutral to the N terminal, this is
used to power the device. The phase cable for the outputs is to the common
of the relay contacts. In every activation, the contacts will provide the phase
to the burner.Avoid installing the phase internally (from the Lterminal to the
relay common terminals) because it might cause interferences. The
outputs are not fuse protected so any short circuit will destroy them and the
device.
The cable power supply shall only be replaced by the manufacturer or his
qualified agent.
Control is intended to be used with the protection of a fuse gG, type B,
IEC60269-3-1.
Suitable for installation in non-conductive areas where conductivity can
occur temporarily due to condensation.
Fig. 4
N
L
230V~
Burner
Boiler
(BS-851/R)
B
Manual Button
WPS Button
A
Boiler Indicator (BS-851)
Burner Indicator
Power/Status
Indicator
LD5
LD4
Programming button BT1
Fig. 5
940851000_09_010
Page 12 from 14
| General | Details |
|---|---|
| Name | olympia electronics BS-850-KIT Wireless Programmable WiFi Electronic Chrono Thermostat User Manual |
| Make | olympia electronics |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.27 MB |
(1 votes, average: 5.00 out of 5)
Loading...
olympia electronics BS-830 Digital Electronic Thermostat Instruction Manual
UNDERFLOOR HEATING WORLD UM1 Thermostat Instruction Manual
ARUNA 302S RF Digital Room Thermostat User Manual
nVent RAYCHEM SENZ Wifi Programmable Floor Heating Thermostat User Guide
BEOK CONTROLS TGT79 Touch Screen Thermostat Instruction Manual
Thermostats BHT-8000RF Wireless Thermostat User Manual
MI-HEAT E51 Thermostat User Manual
FOLODA ME83 Heating Thermostat User Manual
Sygonix 2735095 Wireless Indoor Thermostat Instruction Manual
EMERSON Programmable Touchscreen Thermostat Setup in E2 and Site Supervisor User Guide
Danfoss ECtemp Next Plus Electronic Intelligent Timer Thermostat Installation Guide