Home > Network Thermostat > network thermostat NetX X Series Thermostat Instruction Manual
network thermostat NetX X Series Thermostat Instruction Manual
Independent Power Source cont.
SPECIFICATIONS
WIFI STAT
2. Place the separate transformer 24VAC wire in 24VAC
RATED VOLTAGE: 20V to 30VAC, 24VAC nominal, or 24VDC with jumper removed
terminal.
X-Series
RELAYS - RATED A.C. ⁄ D.C. CURRENT: 0.05 to 0.75 AC / 0.0 to 0.75 DC Amp continuous, per output,
3. Move the WiFi or Ethernet board RED wire from R to the
24VAC terminal.
SETUP
surges to 3 Amps maximum
TEMPERATURE CONTROL RANGE: HEATING: 38 to 88°F (6 to 30°C) in 1° steps
4. Leave the WiFi or Ethernet board BLACK wire in the 24V(c)
terminal. If connected, remove thermostat wire from the
24VAC(c) terminal.
L E D 1
L E D 2
C L K 1
C L K 2
R S 2
R S 1
R S + V
X 2
K / H / D
Y 2
COOLING: 60 to 108°F (16 to 40°C) in 1° steps
HVAC
W 1
Equipment
THERMOSTAT SENSING RANGE: 32˚F to 118°F (0˚C to 48°C) Control Accuracy: ±1°F @ 68°F (±0.5°C @ 20°C)
Y 1
G
5. Place the equipment red wire in R.
R
R
MINIMUM DEADBAND: 2°F (1°C)
Line
Voltage
2 4 V
2 4 V ( c )
O / W 2
B
6. Place the separate transformer 24VAC(Common) wire in
the 24V(c) terminal.
C
DIMENSIONS: 5.1”H x 4.7”W x 1.15”D (130mm x 119mm x 29mm)
X 1
K 2
24 Vac
Transformer
-
EQUIPMENT TERMINATIONS: R - 24V switching voltage, W1 - Heat1 or Aux/Emergency Heat, G - Fan, Y1-Compressor1,
+
7. Common from equipment does not connect to thermostat.
This can cause a ground loop and issues.
Y2 - Compressor2, O/W2 - Heat2 or Rev. Valve in Cooling, B - Rev. Valve in Heating
POWER TERMINATIONS: 24V - remote power, 24V(c) - power common (from HVAC equipment)
HUMIDITY TERMINATIONS: K - Independent Relay, H - Humidify, D - Dehumidify
INDEPENDENT RELAY TERMINATION: K2 - Independent Relay
2
WIRING DIAGRAM CROSS REFERENCE
CHART
The chart below list the connections needed for most
common applications. Refer to the Basic Wiring Diagram for
where to connect appropriate wires.
24V AC or DC
INPUT TERMINATIONS: LED1 (Filter Icon Selectable), LED2 (Fault Icon Selectable)
OCCUPANCY TERMINATIONS: CLK1 ( + ), CLK2 ( – )
REMOTE SENSOR TERMINATIONS: RS+V - Power, RS2 - Return, RS1 - Data
WIRELESS RADIO: 2.4 GHz IEEE 802.11b/g, Security: WEP, WPA-PSK, and WPA2-PSK
Terminals
K/H/D Y2
W1
X
Y1
G
R
X
X
24V(c) O/W2
B
K2
ACCESSORY PORT (X7 Only):
SIM port for NetX CO2/VOC Sensor, NetX DECT/ULE Wireless Sensor Network Host Card
Conventional- Heat only Gas
Conventional- Heat only Electric
X
X
PROTOCOLS:
http, Native NetX API, BACnet-IP and Modbus-TCP/IP over Wi-Fi and Ethernet
(documents at https://www.networkthermostat.com/protocols)
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Conventional- Cool Only
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
CA Title 24 Requirements
FIVE (5) YEAR LIMITED WARRANTY
Conventional- 1H/1C Gas
X
X
X
X
This thermostat meets the Joint Appendix 5 (JA5) requirements
for Occupant Controlled Smart Thermostat (OCST) certification
of the California Energy Commission (CEC).
Network Thermostat™ warrants to the original purchaser that
this product will be free from defects in workmanship and
materials for a period of five years from the date of purchase
with proof of purchase.
Conventional- 2H/2C Gas
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Conventional- 1H/1C Electric
FCC REGULATORY INFORMATION
Warranty Limitations
Conventional- 2H/2C Electric
X
X
This equipment complies with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation, If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
This warranty begins on the date of purchase.
Heat Pump- No Auxiliary Heat Cool Reversing Valve
Heat Pump- No Auxiliary Heat Heat Reversing Valve
Heat Pump- 1 Stage Standard Cool Reversing Valve
Heat Pump- 1 Stage Standard Heat Reversing Valve
Heat Pump- 1 Stage Dual Fuel Cool Reversing Valve
Heat Pump- 1 Stage Dual Fuel Heat Reversing Valve
Heat Pump- 2 Stage Standard Cool Reversing Valve
Heat Pump- 2 Stage Standard Heat Reversing Valve
Heat Pump- 2 Stage Dual Fuel Cool Reversing Valve
Heat Pump- 2 Stage Dual Fuel Heat Reversing Valve
Independent Relay, Humidify, Dehumidify
Independent Relay
Warranty is Void if:
X
X
X
X
X
● The date code or serial number is defaced or removed.
● The product has a defect or damage due to product
alteration, connection to an improper electrical supply,
shipping and handling, accident, fire, flood, lightning or other
conditions beyond the control of the manufacturer.
● The product is not installed according to the manufacturers
instructions and specifications.
X
X
X
X
X
X
X
X
X
X
X
X
Owner’s Responsibility
● Provide proof of purchase.
X
X
X
X
● Reorient or relocate the receiving antenna.
● Provide normal care and maintenance.
● Pay for freight, labor and travel.
● Return any defective product.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
● In no event shall the manufacturer be liable for incidental or
consequential damages.
COPYRIGHT NOTICE
This manual and its content is a copyright of Network
Thermostat - © Network Thermostat 2022. All rights reserved.
This warranty gives you specific legal rights and you may have
others which vary by state and/or province. For example, some
states and/or provinces do not allow the exclusion or limitation of
incidental or consequential damages, so this exclusion may not
apply to you. The manufacturer’s continuing commitment to quality
products may require a change in specifications without notice.
X
BACnet™ is a trademark of ASHRAE
X
Modbus™ is a registered trademark of Schneider Automation Inc.
| General | Details |
|---|---|
| Name | network thermostat NetX X Series Thermostat Instruction Manual |
| Make | Network Thermostat |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.28 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Network Thermostat X7-Series Thermostat Installation Guide
Network Thermostat X7C-WIFI Smart Touchscreen Thermostat Instruction Manual
Network Thermostat X5-WIFI Smart Touchscreen Thermostat Instruction Manual
Network Thermostat NetXTM X-Series Thermostat Installation Guide
network thermostat NetX X5-CFA Universal Setback Thermostat Instruction Manual
network thermostat NetX X-Series Ethernet Thermostat Owner’s Manual
network thermostat X-Series Ethernet Thermostat Instruction Manual
Network Thermostat NetX X7 Series Thermostat Instruction Manual
network thermostat X X7-WIFI Smart Touchscreen Thermostat Instructions
MAGNUM FIRST M9-TS1 24 Volt Intelligent Thermostat Owner’s Manual
YOLINK YS4003-UC Smart Thermostat User Guide
Pro1 Technologies Pro1 T701i WiFi Thermostat Installation Guide
NEOMITIS RTUa Mechanical Room Thermostat Instruction Manual
WarmlyYours 670078B Wifi LED Touch Thermostat User Manual
GENERAL LIFE 270S RF Room Thermostat User Manual
homematic IP C-2 Radiator Thermostat Instruction Manual
GENERAL LIFE MITRA 260S RF Digital Room Thermostat User Manual
MODINE DFG Mild Temperature Thermostat Installation Guide
GENERAL LIFE SENNA 300S Digital Room Thermostat User Manual