Haswill Electronics AL8010H Thermostat User Guide

1

2

3

4

5

AL8010H Thermostat  

Quick Start Guide  

(Version 21.08.02GEN)  

Haswill Electronics AL8010H temperature controller owns  

one 30A output relay to control the power supply status  

of the heater, the temperature ranges from 0 to 300 ℃；  

this PDF instruction show you how to wire it and configure  

https://www.thermo-hygro.com  

it in 15 minutes..  

1. AL8010H Wiring Diagram  

The input power of this controller and the load could be  

the same and different, hence exist two wiring diagrams;  

But please keep in mind that the voltage for this controller  

must same as the diagram shows:  

1 / 5  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	Haswill Electronics AL8010H Thermostat User Guide
Make	HASWILL ELECTRONICS
Language	English
Filetype	PDF (Download)
File size	0.25 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL THERMOSTAT INSTRUCTIONS & USER MANUALS
• HASWILL ELECTRONICS

Haswill Electronics AL8010H Thermostat User Guide Overview

Summary of Contents

• Page 1: AL8010H thermostat quick start guide provides essential information for setup. The temperature controller features a 30A output relay for heater power supply control. Temperature range for the AL8010H is from 0 to 300 ℃. The guide includes instructions on wiring and configuration. There are two wiring diagrams based on whether the input power and load are the same or different. It is crucial to ensure the voltage for the controller matches the diagram specifications.
• Page 2: Page 2
• Page 3: AL8010H Function menu Refrigeration or heating mode Temperature hysteresis / return difference Lower limit for SP Upper limit for SP Temperature calibration Protection delay time for refrigeration Set the temperature Aimed temperature range consists of two parts: SP - D and SP + D Set the SP value
• Page 4: Press the key to save new data. If you found the “SP” cannot reach your ideal value, you must first change the range limitation (LS & HS). Set the “Hysteresis” value by holding the key for 3 seconds to see the code HC. Press the direction key to find the “D.” Press the key to see the current value and press the direction key to change it. Load works conditions when HC = H, works if sensor temp. ≤ SP – Temp. Hysteresis (D). When HC = C, reach all below conditions. The time should be later than the compressor last stops moment + PT.
• Page 5: Restore factory defaults by holding both keys for 8 seconds to see YS indicating success. This is not a step-by-step user manual; it just shows the key points. The new user should read the full-content version user manual. Copyright Haswill-Haswell All Rights Reserved.