GE APPLIANCES RAK150VF2 Digital Wall Thermostat Instruction Manual

GE RAK150VF2 Manual: Questions and Answers

GE RAK150VF2 specifications

Full specifications, page 2

What comes in the box with GE RAK150VF2?

• Thermostat base
• Thermostat cover
• Wiring labels
• Screws
• Wall anchors Instruction Manual, p. 4

How high should I mount the GE RAK150VF2 on the wall?

About five feet above the floor. Instruction Manual, p. 6

How do I connect the wires to the GE RAK150VF2?

Insert stripped, labeled wires into matching terminals by pressing on the corresponding terminal contact.

1. Refer to the Wiring Diagrams section of the manual for proper terminal locations.
2. Press each stripped wire into its matching terminal.
3. Gently tug the wire to confirm proper connection.
4. Double check that each wire connects to the correct terminal.
5. Make sure exposed wire portions do not touch other wires. Instruction Manual, p. 7

What does "No Display" mean on the GE RAK150VF2?

The display is blank when 24 VAC is not present. Check for 24 VAC power. Instruction Manual, p. 15

What happens if I switch to a different mode or change the temperature setting?

The compressor has a 3 minute time delay and a 3 minute minimum run time when it turns on or off. The fan may have a minimum run time or off time delay before responding. Instruction Manual, p. 15

Can I restore the GE RAK150VF2 to factory defaults?

Enter configuration mode and adjust each setting back to its default factory value.

1. Ensure thermostat is in OFF mode.
2. Remove the front cover.
3. Hold CONFIG for approximately 2 seconds to enter configuration mode.
4. Hold CONFIG for approximately 2 seconds to save and exit. Instruction Manual, p. 10

How do I adjust the displayed temperature reading on the GE RAK150VF2?

Use the Room Temperature Offset setting to calibrate the display to match actual room temperature. The offset range is +9°F to -9°F or +5°C to -5°C.

1. Ensure thermostat is in OFF mode.
2. Remove the front cover.
3. Hold CONFIG for approximately 2 seconds.
4. Press FAN repeatedly to reach screen 8, Room Temperature Offset.
5. Press the up or down button to select your offset value.
6. Hold CONFIG for approximately 2 seconds to save and exit. Instruction Manual, p. 10

GE RAK150VF2 compared with other GE thermostats

More GE thermostat manuals

• GE RAK160W2
• GE RAK190V Management
• GE RAK190V Way Management
• GE SST-W300