Home > COMPUTHERM > COMPUTHERM Q5RF Multi Zone Wireless Digital Room Thermostat Instruction Manual

COMPUTHERM Q5RF Multi Zone Wireless Digital Room Thermostat Instruction Manual

and keep it depressed (for approximately 10 seconds) until the  
green LED starts flashing. After this, press the “LEARN” button  
of the thermostat (approx. 10 seconds) until the green LED on the  
socket/sockets stops flashing. After the two units have been syn-  
chronized, the thermostat controls the plug according to the tem-  
perature setting. When the thermostat is switched on, 230 V, 50  
Hz mains voltage appears on the output socket of the plug.  
For more information of tuning, refer to the operating instruction of  
the COMPUTHERM Q1RX socket.  
7.3 Transmission distance inspection  
With the help of the  
and  
buttons you can check  
whether the two units are within the transmission distance of  
the wireless (radio-frequency) connection. In order to do so, set  
the desired temperature above room temperature by more than  
0.2 °C, then reduce it below the room temperature by more than  
0.2 °C. When detecting the ON and OFF control signals, the  
red LED on the receiver unit or the COMPUTHERM Q1RX plug  
switches on and off, respectively. When the receiver unit / plug  
fails to receive signals sent by the thermostat, then the receiver  
unit / plug is outside the transmission distance of the wireless  
- 17 -  
GeneralDetails
NameCOMPUTHERM Q5RF Multi Zone Wireless Digital Room Thermostat Instruction Manual
MakeCOMPUTHERM
LanguageEnglish
FiletypePDF (Download)
File size0.32 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
COMPUTHERM E800RF Multizone Wi-Fi Thermostat Instruction Manual
COMPUTHERM E800RF Multizone Wi-Fi Thermostat Instruction Manual
COMPUTHERM Q20 Programmable Digital Room Thermostat Instruction Manual
COMPUTHERM Q20 Programmable Digital Room Thermostat Instruction Manual