Vine Smart Wi-Fi Thermostat with Nightlight TJ-225 User Guide

Vine Nightlight TJ-225 Manual: Questions and Answers

How do I install the Vine Nightlight TJ-225 on my wall?

Mount the new wall plate using the enclosed screws and anchors, then connect the wires.

1. Turn off power at the breaker box or switch.
2. Remove your old thermostat by gently pulling it from the wall plate.
3. Take a picture of the existing wiring for reference.
4. Label each wire using the label provided with your new thermostat.
5. Disconnect wires from the old wall plate one by one with a screwdriver if needed.
6. Mount the new wall plate using enclosed screws and anchors in the same position as before. User Guide, p. 5

What voltage does the Vine Nightlight TJ-225 require?

24V-AC low voltage for heating and cooling systems. User Guide, p. 2

Where are the mounting clips on the Vine Nightlight TJ-225?

Two clips are on the back of the TJ-225 and align into corresponding slots on the top of the wall plate. User Guide, p. 14

More Vine thermostat manuals

• Vine TJ-560
• Vine TJ-610E