TRANE XR102 Non-Programmable Thermostat User Guide
Installation and User Guide
5.2 OPERATING FEATURES
Now that you are familiar with the thermostat buttons and display, read the following information to learn about the many features of the
thermostat.
•
•
•
•
SIMULTANEOUS HEATING/COOLING SETPOINT STORAGE — You can enter both your heating and cooling setpoints at the
same time. There is no need to re-enter the thermostat at the beginning of each season.
TEMPERATURE SETTING — Press
room temperature at the selected temperature.
or
until the display shows the temperature you want. The thermostat will keep the
°F/°C CONVERTIBILITY — The factory default setting is Fahrenheit. Clipping W904 jumper on the circuit board will alter this
feature to Celsius temperature setting. See diagram on page 11.
LOW BATTERY INDICATOR — If the 2 “AAA” alkaline batteries are low and should be replaced, the display will be blank except for
. When the batteries are low, pressing any button will cause the display to operate for ten seconds. After ten seconds,
the display will be blank except for
temperature 10° above your setpoint in COOL mode and drop the temperature 10° below your setpoint in HEAT mode.
. After
has been displayed for 4 weeks, the thermostat will raise the
•
TEMPERATURE DISPLAY ADJUSTMENT — Your new thermostat has been accurately set in our factory. However, if you wish,
you may adjust your new thermostat temperature display to match your old thermostat. This can be accomplished (within a 3°
range) as follows:
1. Press
2. Press
or
or
at the same time for two seconds with the SYSTEM switch in OFF position.
to adjust the displayed temperature to your desired setting
3. Move SYSTEM switch from OFF to exit the feature
•
DISPLAY BACKLIGHT — The display backlight improves display contrast in low lighting conditions. Selecting backlight ON will turn
the light on for a short period of time after any button is pressed. Selecting backlight OFF (default) will keep the light off. Turn the
display backlight feature ON as follows:
1. Press
“-L” AND “FF” (off).
2. Press or
and
at the same time for two seconds with the SYSTEM switch in HEAT position. The display will alternately show
to change “FF” to “ON.”
3. Move SYSTEM switch to OFF to exit the feature.
10
Pub. No. 18HD54D1-1B-EN 03/2020 Part No. 37-7770002
| General | Details |
|---|---|
| Name | TRANE XR102 Non-Programmable Thermostat User Guide |
| Make | Trane |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.3 MB |
(1 votes, average: 5.00 out of 5)
Loading...
TRANE BAYECON089A Programmable Touch Screen Thermostat Instruction Manual
TRANE XR103 Non-Programmable Heat Pump Thermostat User Guide
TRANE XR202 Programmable Thermostat User Guide
TRANE SC360 Link System Controller and Smart Thermostat Instructions
BARD THERMOSTAT Menu Driven Display 1120-445A User Manual
Braebur 1230 Non Programmable Thermostat Instruction Manual
telkonet Aida Wireless Thermostat User Guide
ELKO EKO07258 16A Smart ZB Thermostat User Guide
Danfoss ECtemp 610 Electronic Thermostat Installation Guide
SALUS CONTROLS T105 Digital Programmable Thermostat User Guide
Danfoss RET1000 Series Electronic Thermostat User Guide
Roth VVS-nr. 466397.058 Softline Standard Room Thermostat Instruction Manual
DELTA DORE TYBOX 1117 Programmable Thermostat User Guide
HERSCHEL T-BT Battery Powered Wireless Thermostat Instruction Manual