PELICAN TC1 Commercial Connected Thermostat Installation Guide
Attach the Display
Before attaching the display, write down the
serial number displayed on the screen. This
number will be needed when configuring
the thermostat.
Align the display with the back plate’s
alignment pins, then press it into the back
plate until it clicks into place.
Turn on the power to the HVAC equipment
connected to the thermostat.
If your Pelican thermostat does not power
on, refer to page 16 for troubleshooting.
For instructions on setting up Conventional
or Heat Pump control, refer to page 17.
there are three (3) alignment
pins found on the left and right
sides of the base plate.
Optional: Tamper Resistant Lock
The thermostat has an internal locking
mechanism that secures the display to the
back plate, preventing unauthorized access
to the power and thermostat wires.
To engage the lock, assemble the
thermostat and insert a 1/8" flat-head
screwdriver into the hole on the left side of
the thermostat. Push in slightly and turn 1/4
turn clockwise until it reaches the stop.
Then, remove the screwdriver.
To disengage the lock, insert a 1/8" flat-head
screwdriver into the same hole and turn 1/4
turn counter-clockwise until it reaches the
stop. Remove the screwdriver.
Do NOT attempt to force the display off the
back plate, as this could cause damage.
7
| General | Details |
|---|---|
| Name | PELICAN TC1 Commercial Connected Thermostat Installation Guide |
| Make | Pelican |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.32 MB |

PELICAN TC4 Commercial Connected Thermostat Installation Guide

PELICAN TC3 Commercial Connected Thermostat Installation Guide

































