Home > Pelican > PELICAN TC1 Commercial Connected Thermostat Installation Guide

PELICAN TC1 Commercial Connected Thermostat Installation Guide

Limited Wire Installation  
In some installations, there may be  
limited wiring between the thermostat  
and the HVAC equipment. The  
Wiring Module  
included Wiring Module allows control  
of the HVAC system without the need  
to install new or additional wires.  
This setup requires at least three (3)  
wires between the thermostat and the  
Wiring Module (unshielded wire is  
acceptable).  
It supports a maximum distance of  
500 feet between the Wiring Module  
and the thermostat.  
Step 1: Remove the Wiring Module  
from the thermostat’s back plate.  
Loosen the (R), (C), and (D)  
terminals on the Wiring Module.  
Gently slide the Wiring Module  
upwards, away from the three-pin  
connector, to remove it.  
Loosen  
terminals.  
Three pin  
connector  
Step 2: Install the Wiring Module in  
the HVAC equipment.  
Use a sheet metal  
screw to secure the  
Wiring Module.  
Wiring Module  
Locate the HVAC equipment’s  
control board. Using new wire,  
connect the Wiring Module’s  
terminals to the corresponding  
low-voltage input terminals on the  
HVAC control board.  
HVAC Control Board  
Y2  
W2  
G
W
Y
Refer to the wiring diagrams on  
Pages 8–15 for the most common  
thermostat wiring.  
R
C
5
GeneralDetails
NamePELICAN TC1 Commercial Connected Thermostat Installation Guide
MakePelican
LanguageEnglish
FiletypePDF (Download)
File size0.32 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
PELICAN TC4 Commercial Connected Thermostat Installation Guide
PELICAN TC4 Commercial Connected Thermostat Installation Guide
PELICAN TC3 Commercial Connected Thermostat Installation Guide
PELICAN TC3 Commercial Connected Thermostat Installation Guide

PELICAN TC1 Commercial Connected Thermostat Installation Guide