Home > EUROTRONIC > eurotronic Comet Zigbee Energy Saving Radiator Thermostat Instruction Manual
eurotronic Comet Zigbee Energy Saving Radiator Thermostat Instruction Manual
5.7 DISMOUNTING COMET ZIGBEE
Remove the Comet Zigbee from the network before disassembling the device. To do this, please put your Zigbee
controller in the removal mode (Exclusion). Then press and hold the button in the battery compartment for 5 seconds
(Fig.7). The LED display shows Node ID 0 if the removal was successful and the valve tappet moves into mounting po-
sition. Wait until the display shows “PA”. Now unscrew the union nut counterclockwise and remove it from the Comet
Zigbee valve (Fig.8).
5.8 FACTORY RESET
Press and hold the button in the battery compartment of your Comet Zigbee for at least 10 seconds. From the 5th
second on, a counter will run on the thermostat’s display. Keep the button pressed until the 10 appears on your Comet
Zigbee. Then “Ad” will be shown again on the display and the controller will be in pairing mode.
NOTE: Use the factory reset only if your primary Zigbee controller is no longer available or is inoperable for other rea-
sons.
Counter counts up from 5 to 10. After reaching 10, the display
shows “PA” again.
The pairing mode is active again.
Device
XY
removed.
– 12 –
| General | Details |
|---|---|
| Name | eurotronic Comet Zigbee Energy Saving Radiator Thermostat Instruction Manual |
| Make | EUROTRONIC |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.47 MB |

EUROTRONIC Programmable Energy-Saving Radiator Thermostat User Manual

EUROTRONIC Sparmatic COMET Programmable Energy-Saving Radiator Thermostat User Manual

EUROTRONIC SPIRIT ZigBee Energy Saving Thermostat User Guide

EUROTRONIC COMET Programmable Energy Saving Radiator Thermostat User Manual

EUROTRONIC Spirit ZigBee Energy Saving Radiator Thermostat User Guide
































