Ebeco EB-Therm 55 Thermostat User Manual

Ebeco EB-Therm 55 Manual: Questions and Answers

Ebeco EB-Therm 55 specifications

Full specifications, page 31

What temperature accuracy does the Ebeco EB-Therm 55 maintain?

Floor temperature varies less than +/- 0.3 degrees, achieved through fuzzy technology that learns from system behavior. User Manual, p. 20

How do you lock the knob on the Ebeco EB-Therm 55?

Remove the knob. Adjust the two plastic parts to set your desired interval. Reinstall the knob. User Manual, p. 29

What's the difference between floor thermostat and room and floor thermostat mode on the Ebeco EB-Therm 55?

User Manual, p. 26

Why is there a delay before the heating turns off after I lower the temperature?

Built-in 30-second delay prevents unnecessary wear on internal components and extends thermostat life. User Manual, p. 29

Can the floor sensor be replaced in the Ebeco EB-Therm

Yes, if it's installed in a spiral hose laid in the floor as instructed. User Manual, p. 30

How do I install the Ebeco EB-Therm into the wall box?

Mount it in a 65mm standard appliance box following these steps:

1. Ensure the box is level with the wall.
2. Remove the knob and undo the screw, then lift off the front and frame.
3. Connect 230 VAC power, load, and floor sensor cable.
4. Insert the thermostat into the box and screw tight with existing screws.
5. Mount the frame, front, and knob back in place.
6. If using a multi-compartment frame, remove the internal corners. User Manual, p. 23

When should I turn on the underfloor heating after installation on the Ebeco EB-Therm 55?

Wait 2-4 weeks after installation before starting, depending on your floor type and putty instructions. Then increase heat gradually. User Manual, p. 24

Ebeco EB-Therm 55 compared with other floor heating thermostats

More Ebeco thermostat manuals

• Ebeco EB-Therm 205
• Ebeco EB-Therm 500
• Ebeco EB500