Home > CYDATA > CYDATA DAISY Wi-Fi Enabled Thermostat Installation Guide

CYDATA DAISY Wi-Fi Enabled Thermostat Installation Guide

INSTALLING THERMOSTAT  
4
Remove the wallplate.  
After all wires have been labeled and disconnecte
remove the existing wallplate from the wall.  
5
Separate the new Wi-Fi thermostat from its wall plate  
Grab hold of the back corners while holding the front of  
the new thermostat. Hold the wallplate tightly to pull the  
thermostat apart.  
6
Mount new Wi-Fi thermostat wallplate  
Screws and anchors are provided to mount  
the new wallplate. Existing wall anchors may  
be usable and can be checked by holding  
the new wallplate up to the anchors  
to check that they are in alignment.  
Note: Wiring will be specific to each application  
and may be different than wiring shown above.  
7
Wiring for conventional system.  
Note: You must have a C Wire or equivalent.  
a Start with the C wire to match the tag on the wire  
to the terminal label.  
b Loosen the screw. Insert wire on inside edge  
of terminal, then tighten screw.  
c Give wire a gentle tug to confirm wire is secure.  
Wiring  
d Repeat steps a-c for remaining wires.  
cross reference  
Conventional  
Heat pump  
e Excess wire should be pushed back into  
opening of wall.  
RC  
R
Y
C
O/B  
G
AUX/E  
L
f
Continue to step 8 on page 5.  
Note: Remove metal jumper only if you  
have both R and RC wires.  
DAISY Wi-Fi Programmable Thermostat / INSTALL GUIDE  
3
GeneralDetails
NameCYDATA DAISY Wi-Fi Enabled Thermostat Installation Guide
MakeCYDATA
LanguageEnglish
FiletypePDF (Download)
File size0.37 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
CYDATA CY917B Daisy Wi-Fi Thermostat User Guide
CYDATA CY917B Daisy Wi-Fi Thermostat User Guide

CYDATA DAISY Wi-Fi Enabled Thermostat Installation Guide