Home > American Standard > American Standard ACONT102 Non Programmable Thermostat User Guide
American Standard ACONT102 Non Programmable Thermostat User Guide
Installation and User Guide
5.2 OPERATING FEATURES
Now that you are familiar with the thermostat buttons and display, read the following information to learn about the many features of the
thermostat.
•
•
•
•
SIMULTANEOUS HEATING/COOLING SETPOINT STORAGE — You can enter both your heating and cooling setpoints at the
same time. There is no need to re-enter the thermostat at the beginning of each season.
TEMPERATURE SETTING — Press
room temperature at the selected temperature.
or
until the display shows the temperature you want. The thermostat will keep the
°F/°C CONVERTIBILITY — The factory default setting is Iahrenheit. Clipping W904 mumper on the circuit board will alter this
feature to Celsius temperature setting. See diagram on page 11.
LOW BATTERY INDICATOR — If the 2 “AAA” alkaline batteries are low and should be replaced, the display will be blank except
for
seconds, the display will be blank except for
. When the batteries are low, pressing any button will cause the display to operate for ten seconds. After ten
. After has been displayed for 4 weeks, the thermostat will
raise the temperature 10° above your setpoint in COOL mode and drop the temperature 10° below your setpoint in HEAT mode.
•
TEMPERATURE DISPLAY ADJUSTMENT — Your new thermostat has been accurately set in our factory. However, if you wish,
you may adjust your new thermostat temperature display to match your old thermostat. This can be accomplished (within a ±3°
range) as follows:
1. Press
2. Press
or
or
at the same time for two seconds with the SYSTEM switch in OFF position.
to adjust the displayed temperature to your desired setting
3. Move SYSTEM switch from OFF to exit the feature
•
DISPLAY BACKLIGHT — The display backlight improves display contrast in low lighting conditions. Selecting backlight ON will
turn the light on for a short period of time after any button is pressed. Selecting backlight OFF (default) will keep the light off. Turn
the display backlight feature ON as follows:
1. Press
“-L” AND “FF” (off).
2. Press or
and
at the same time for two seconds with the SYSTEM switch in HEAT position. The display will alternately show
to change “FF” to “ON.”
3. Move SYSTEM switch to OFF to exit the feature.
10
Pub. No. 11HD23D1-1B-EN 09/2020 Part No. 37-7771002
| General | Details |
|---|---|
| Name | American Standard ACONT102 Non Programmable Thermostat User Guide |
| Make | American Standard |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.4 MB |
(1 votes, average: 5.00 out of 5)
Loading...
American Standard ACONT103 NP Non Programmable Heat Pump Thermostat Instruction Manual
LUTRON 653 Right Thermostat Control Datasheet
GENERAL LIFE HT330S RF Room Thermostat User Manual
Braebur 1230 Non Programmable Thermostat Instruction Manual
VILPE WIVE 100 Intake Vent Plus Thermostat
SALUS SQ610 Smart Thermostat User Guide
vtech T961NN50 Universal Wired Thermostat User Guide
DEVIreg 330 Electronic Thermostat Installation Guide
TRANE SC360 Link System Controller and Smart Thermostat Instructions
EXPERT4HOUSE BAC-9000 Smart Knob Thermostat User Guide
EUROTRONIC Spirit ZigBee Energy Saving Radiator Thermostat User Guide