Hotwire HWTH Horizontal Thermostat Instructions
HotwireThermostat
Instructions
Manual Mode
Installation and Wiring
HEATING MODE
Press
to select Auto/Manual mode. In Manual mode, the
thermostat maintains a constant set temperature manually set by the user. A
sun and flame symbol is displayed. To increase the temperature press the
Degrees and then increase or decrease by pressing the + or - buttons.
When off Moon is displayed. Or if you are going way select the suitcase and
the heating will stay off until you return.
Carefully separate the front half of the thermostat from the back plate by
unscrewing the small screw at the bottom of the thermostat. Carefully unplug the
ribbon connector which is plugged into the front half of the thermostat. Place the
thermostat front half somewhere safe. Terminate the thermostat as shown in the
diagrams below.
Lock the Keypad
Screw the thermostat back plate onto the flush box
To lock the keypad press and hold the bottom left hand corner of the screen for
5 seconds. To unlock repeat.
Re-connect the thermostat ribbon cable and clip the two halves together.
Reset to Factory Setting
The conduct a master reset to factory settings, press the power button to turn
the thermostat off. Press and hold Menu for 5 seconds. Move to menu 17 then
hold the down button for 5 seconds.
L
N
N
L
Floor Sensor
FEED
(230VAC)
LOAD (16A)
Connect green wire from the element to the house earth.
This product should be installed by
a qualified electrician.
| General | Details |
|---|---|
| Name | Hotwire HWTH Horizontal Thermostat Instructions |
| Make | Hotwire |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.26 MB |

HWGL2 Hotwire Thermostat Instructions

HWTH Horizontal Hotwire Thermostat Instructions

Hotwire HWGL2 Dual Programming Thermostat Instructions

HotWire R220 WiFi Thermostat Instruction Manual

















