Home > WarmlyYours > WarmlyYours UTN5-4999 Thermostat User Guide
WarmlyYours UTN5-4999 Thermostat User Guide
Setting Up the nTrust 2.0 UTN5-4999
The following instructions are for the initial setup, or setup after a factory reset, of the
non-programmable thermostat.
With the Thermostat powered on, press the Center Square icon on the face of the Thermostat.
The thermostat Start-Up Wizard will then step through the thermostat default settings:
UN - Unit.
Press Circle to select.
Arrow
to F (Fahrenheit) or C (Celsius).
Press Circle to select.
Arrow Down to the next setting.
SE - Sensor.
Press Circle to select.
Arrow
to F (Floor), R (Room), RF (Room/Floor), or S (Sensorless / Regulator mode).
Press Circle to select.
Arrow Down to the next setting.
PR - Protection.
Press Circle to select.
Arrow
to W (Wood), L (Laminate), T (Tiles), or OF (Off).
Press Circle to select.
Arrow Down to the next setting.
TE - Test GFCI.
Press and release the button on the outside top of the thermostat to trip (test) the built-in GFCI.
Press and release the lower right-side button on the outside of the thermostat to reset the GFCI.
The nTrust 2.0 Thermostat will then save these new default settings and display the current temperature. To adjust
the temperature, wake up the thermostat by touching the screen and arrowing to the desired heated temperature.
Once selected, it will blink a couple of times and then revert to the sensed temperature on the display before going
back to sleep. Note: An orange LED will come on when the thermostat is energizing the heaters.
| General | Details |
|---|---|
| Name | WarmlyYours UTN5-4999 Thermostat User Guide |
| Make | WarmlyYours |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.04 MB |

WarmlyYours 670078B Wifi LED Touch Thermostat User Manual

WarmlyYours TH115-AF-GA-08 SmartStat TH115 Series Thermostat Instruction Manual














