WarmlyYours UTN5-4999 Thermostat User Guide

1

Setting Up the nTrust 2.0 UTN5-4999  

The following instructions are for the initial setup, or setup after a factory reset, of the  

non-programmable thermostat.  

With the Thermostat powered on, press the Center Square icon on the face of the Thermostat.  

The thermostat Start-Up Wizard will then step through the thermostat default settings:  

UN - Unit.  

Press Circle to select.  

Arrow  

to F (Fahrenheit) or C (Celsius).  

Press Circle to select.  

Arrow Down to the next setting.  

SE - Sensor.  

Press Circle to select.  

Arrow  

to F (Floor), R (Room), RF (Room/Floor), or S (Sensorless / Regulator mode).  

Press Circle to select.  

Arrow Down to the next setting.  

PR - Protection.  

Press Circle to select.  

Arrow  

to W (Wood), L (Laminate), T (Tiles), or OF (Off).  

Press Circle to select.  

Arrow Down to the next setting.  

TE - Test GFCI.  

Press and release the button on the outside top of the thermostat to trip (test) the built-in GFCI.  

Press and release the lower right-side button on the outside of the thermostat to reset the GFCI.  

The nTrust 2.0 Thermostat will then save these new default settings and display the current temperature. To adjust  

the temperature, wake up the thermostat by touching the screen and arrowing to the desired heated temperature.  

Once selected, it will blink a couple of times and then revert to the sensed temperature on the display before going  

back to sleep. Note: An orange LED will come on when the thermostat is energizing the heaters.  

Installation Support • (800) 875-5285 • www.WarmlyYours.com  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	WarmlyYours UTN5-4999 Thermostat User Guide
Make	WarmlyYours
Language	English
Filetype	PDF (Download)
File size	0.04 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL THERMOSTAT INSTRUCTIONS & USER MANUALS
• WarmlyYours

WarmlyYours UTN5-4999 Thermostat User Guide Overview

Summary of Contents

• Page 1: Setting up the nTrust 2.0 UTN5-4999 involves initial setup or setup after a factory reset of the non-programmable thermostat. With the thermostat powered on, press the Center Square icon to access the Start-Up Wizard. The wizard will guide you through the thermostat default settings. Select the unit type (Fahrenheit or Celsius) and press Circle to confirm. Choose the sensor type (Floor, Room, Room/Floor, or Sensorless/Regulator mode). Select the protection type (Wood, Laminate, Tiles, or Off). Test the GFCI by pressing the button on the outside top of the thermostat. Reset the GFCI using the lower right-side button on the thermostat. The thermostat will save the new settings and display the current temperature. To adjust the temperature, wake up the thermostat and select the desired heated temperature.