SEALEY FH2010.V2 2000W Fan Heater with Thermostat User Manual

1

2

3

FAN HEATER 2000W 2 HEAT SETTINGS WITH  

THERMOSTAT  

MODEL NO: FH2010.V2  

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,  

and properly maintained, give you years of trouble free performance.  

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE  

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR  

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.  

Refer to  

instruction  

manual  

DO NOT  

cover  

Indoor use only  

1. SAFETY  

THIS PRODUCT IS ONLY SUITABLE FOR WELL INSULATED AREAS OR OCCASIONAL USE.  

ELECTRICAL SAFETY  

1.1.  

‰

WARNING! It is the user’s responsibility to check the following:  

9

Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and  

all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical  

products.  

Electrical safety information. It is important that the following information is read and understood:  

Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.  

Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.  

Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the  

correct fuse.  

9

9

8

8

8

DO NOT pull or carry the appliance by the power cable.  

DO NOT pull the plug from the socket by the cable.  

DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or is replaced immediately by a  

qualified electrician.  

If the cable or plug is damaged during use, switch off the electricity supply and remove from use.  

Ensure that repairs are carried out by a qualified electrician.  

If an extension reel is used it should be as short as possible and fully unwound before connection. A reel with an RCD fitted is preferred  

since any appliance plugged into it will be protected. The cable core section is important and should be at least 1.5mm², but to be  

absolutely sure that the capacity of the reel is suitable for this product and for others which may be used in the other output sockets, we  

recommend the use of 2.5mm² section cable.  

1.2.  

GENERAL SAFETY  

‰

WARNING! Disconnect the heater from the mains power, before servicing or performing any maintenance. Servicing or maintenance  

must only be carried out by an authorised service agent.  

9

‰

8

Check that the heater is in sound condition and good working order. Take immediate action to repair or replace damaged parts.  

WARNING! DO NOT use the heater near flammable material, liquids, solids, gases or compressed gas cylinders etc.  

DO NOT allow any untrained or incompetent persons use the heater. Ensure they are familiar with the controls and hazards of the  

heater.  

8

‰

DO NOT use this heater in the immediate surroundings of a bath, a shower or a swimming pool.  

WARNING! DO NOT use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own,  

unless constant supervision is provided.  

‰

WARNING! To reduce the risk of fire, keep textiles, curtains, or any other flammable material to a minimum distance of 1m from the air  

outlet.  

8

8

9

8

8

8

8

8

8

8

8

8

8

8

8

8

8

9

DO NOT use this heater if it has been dropped.  

DO NOT use if there are visible signs of damage to the heater.  

Use this heater on a horizontal and stable surface, or fix it to a wall as applicable.  

DO NOT allow children to touch or to operate the heater  

DO NOT obstruct the air inlet or outlet on the heater.  

DO NOT cover the heater.  

DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication.  

DO NOT touch the heater casing or grill when first switched off as these are hot and will take time to cool.  

DO NOT use the heater for anything other than its intended purpose. It is not suitable for drying clothes or laundry.  

DO NOT place the heater close to a bath, wash basin, shower, swimming pool or any other water-filled area or wet surface.  

DO NOT get the heater wet or use in areas of high condensation.  

DO NOT place the heater up against any surface such as a wall, door or furniture etc.  

DO NOT place the heater immediately below any electrical outlet.  

DO NOT allow the power lead to lie in front of the heater outlet.  

DO NOT attempt to repair a damaged heater, contact an authorised service agent.  

DO NOT stand on the heater.  

DO NOT connect the fan heater to a timer device or other equipment that can automatically switch the heater on or off.  

Ensure that the heater is correctly turned off when not in use and store in a safe, dry area, out of reach of children.  

© Jack Sealey Limited  

Original Language Version  

FH2010.V2 Issue:6 (1) 07/11/23  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	SEALEY FH2010.V2 2000W Fan Heater with Thermostat User Manual
Make	SEALEY
Language	English
Filetype	PDF (Download)
File size	0.18 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL THERMOSTAT INSTRUCTIONS & USER MANUALS
• SEALEY

SEALEY FH2010.V2 2000W Fan Heater with Thermostat User Manual Overview

Summary of Contents

• Page 1: FAN HEATER 2000W 2 HEAT SETTINGS WITH THERMOSTAT Thank you for purchasing a Sealey product. This product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance. Important: Please read these instructions carefully. Note the safe operational requirements, warnings & cautions. Use the product correctly and with care for the purpose for which it is intended. This product is only suitable for well-insulated areas or occasional use. Warning! It is the user’s responsibility to check all electrical equipment and appliances to ensure that they are safe before using. Disconnect the heater from the mains power before servicing or performing any maintenance. Warning! Do not use the heater near flammable material, liquids, solids, gases or compressed gas cylinders. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided. To reduce the risk of fire, keep textiles, curtains, or any other flammable material to a minimum distance of 1m from the air outlet. Do not use the heater for anything other than its intended purpose. It is not suitable for drying clothes or laundry.
• Page 2: Children aged from 3 years and less than 8 years shall only switch on/off the appliance under supervision and instruction. Children aged from 3 years and less than 8 years shall not plug in, regulate, clean the appliance, or perform user maintenance. Children of less than 3 years should be kept away unless continuously supervised. The heater has a tough composite case with an integral carry handle and can be seated in a vertical or horizontal position. It features a full range ambient room thermostat and a fan that doubles as a cool air blower for summer use. The heater operates at two power settings: 1000W and 2000W. Position the heater on a level surface ensuring air intake and outlet are unobstructed. The heater will switch on when the selector switch is set to one of the power settings and will maintain the set temperature automatically. Before maintenance, ensure the unit is unplugged and cool; clean with a soft dry cloth and check the heater grille for blockages. Dispose of the product in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE) at the end of its working life.
• Page 3: Information requirements for electric local space heaters Model identifier(s): FH2010.V2 Type of heat input for electric storage local space heaters only Nominal heat output Minimum heat output (indicative) Manual heat charge control with room and/or outdoor temperature feedback Electronic heat charge control with room and/or outdoor temperature feedback Maximum continuous heat output Fan assisted heat output Auxiliary electricity consumption Type of heat output/room temperature control