Home > Midea > Midea KJR-29B-BK-E Wireless Thermostat Instruction Manual

Midea KJR-29B-BK-E Wireless Thermostat Instruction Manual

MCAC-VTSM-2013-03  
R410A DC Inverter V4 Plus 50Hz  
Wiring figure:  
1) Connect two terminals of embedded 4-core shielding wire with the switching wires of wired remote controller  
and signal receiving board. Make sure the sequence of 4 terminals (A/B/C/D) should correspond to the wire  
sequence of signal switching wires (A/B/C/D).  
Attached connecting wires for the signal receiving panel  
C
C
+5V  
D
D
D
C
GND  
A
A
A
B
IR+  
B
B
Front cover  
Control panel  
IR-  
Screw  
Signal switching wire  
4-core shielding wire embedded in the wall  
Signal receiving panel  
2) If embedded 4-core shielding wire cannot go through the wired controller, it can use signal switching for  
connection and make sure the wires are reliable and firm. The tightening torque range of the screw  
is0.8~1.2N .m (8~12 kgf . cm).  
Attached connecting wires for  
the signal receiving panel  
4-core shielding wire  
embedded in the wall  
Back cover installation  
1) Use straight head screwdriver to insert into the buckling position in the bottom of a wired controller, and spin  
the screwdriver to take down the back cover. (Pay attention to spinning direction, if not you maybe damage the  
back cover.)  
Buckling position  
Back cover  
Front cover  
Straight head screwdriver  
Control System  
GeneralDetails
NameMidea KJR-29B-BK-E Wireless Thermostat Instruction Manual
MakeMidea
LanguageEnglish
FiletypePDF (Download)
File size0.33 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

Midea KJR-29B-BK-E Wireless Thermostat Instruction Manual