Home > Honeywell Home > Honeywell Home S200 Series FocusPRO Smart Thermostat User Guide

Honeywell Home S200 Series FocusPRO Smart Thermostat User Guide

1

2

3

4

CAUTION

Equipment damage hazard.

To prevent possible compressor

damage, do not operate cooling

system when outdoor temperature

is below 50°F (10°C).

Troubleshooting

If you have difficulty with your thermostat, please try the following suggestions. Most problems can be corrected quickly and easily.

Display is blank

•

Check circuit breaker and reset if necessary.

Make sure power switch at heating and cooling system is on.

Make sure furnace door is closed securely.

“Waiting for equipment” appears

on the screen

•

Compressor protection feature is engaged. Wait 5 minutes for the system to restart safely, without damage to the compressor.

Temperature settings do not change

•

If display says “unlock”, thermostat owner has set a lockout setting. If not, verify you are in the correct mode (heat, cool, em heat or auto); see page 1.

If you are in the correct mode, but you cannot set the heat from 32 °F to 90 °F (0 °C to 32 °C), or set the cool from 50 °F to 99 °F

(10 °C to 37 °C), you may have range-stops restricting your setting. Check with the installer to see if they set range-stops.

Resideo Technologies Inc.

Scottsdale, AZ 85254

33-00685EA KK 12-24

www.resideo.com

The Honeywell Home trademark is used under license from Honeywell International, Inc. This product is manufactured by Resideo Technologies, Inc. and its affiliates.