Home > ezlo > ezlo EZL-TSTAT-US Wave Thermostat Instruction Manual

ezlo EZL-TSTAT-US Wave Thermostat Instruction Manual

Including the Z-Wave Thermostat  
to an Ezlo Z-Wave Hub  
Step 1:  
In the MiOS app:  
1. Open the MiOS app and press on “More”  
2. Tap on ”Devices” then press on “+” in the top  
right corner.  
3. Select your Ezlo Z-Wave Hub from the  
Controllers list  
4. Choose “Generic Z-Wave Devices” and press  
Next”  
5. The Ezlo Z-Wave Hub is now waiting for your to  
make the Adding/Removing procedure from the  
thermostat side.  
Step 2:  
In the Ezlo Z-Wave Thermostat menu:  
Under the normal working interface, long press “”  
and “” buton simultaneously for 3sec, the device  
will enter Z-WAVE MENU interface for INCLUSION  
or EXCLUSION as show in the image below Before  
the device included into a network,  
“- - -” will be displayed on the screen. Then short  
press “” buton and device will enter learning  
mode to get a node ID. If INCLUSION is a success,  
a node ID will be displayed on the screen in a few  
seconds. Long press "" and "" buton  
simultaneously for 3sec or after 20sec without any  
operation will back to main page.  
Note: Follow the same steps to exclude the device  
from the network. When removed from the  
Z-Wave network, the device restores it’s Z-Wave  
factory seting.  
200 Broadacres Dr, Bloomfield, NJ 07003  
28  
866-966-2272 • ezlo.com  
property. empowered.  
GeneralDetails
Nameezlo EZL-TSTAT-US Wave Thermostat Instruction Manual
Makeezlo
LanguageEnglish
FiletypePDF (Download)
File size0.63 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

ezlo EZL-TSTAT-US Wave Thermostat Instruction Manual