aube Electronic Thermostat TH131 Owner’s Manual
TH131
Power
Terminals 1 & 5
Load
Terminals 2 & 4 (see note 1)
Terminal 3 (see note 2)
Pilot Wire
Floor sensor
Terminals 6 & 7; no polarity (see note 3)
NOTE 1 If a contactor is used between the thermostat and the load, install a
snubber at the contactor’s coil terminal to ensure the proper operation
of the thermostat.
NOTE 2 Optional (see page 10).
NOTE 3 For the proper operation of the thermostat, the floor sensor must be
centered between two heater wires having a maximum temperature
of 80°C (176°F). The floor sensor wire must not cross any heater wire
or be placed close to it.
NOTE 4 Ensure that the wires are tightly secured to the terminals. Apply a
minimum torque of 0.5 Nm (4.4 Lb/in) when tightening the screws.
NOTE 5 The terminals are designed to handle a cross-section of wire
2
measuring 0.33 to 3.1 mm .
7
| General | Details |
|---|---|
| Name | aube Electronic Thermostat TH131 Owner’s Manual |
| Make | aube |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.57 MB |
(1 votes, average: 5.00 out of 5)
Loading...
aube TH146-P-2H1C Programmable Thermostat Installation Guide
aube TH114-AF-GA Non-Programmable Thermostat Owner’s Manual
ENGO CONTROLS E55-B, E55-W Wi-Fi Thermostat User Guide
Honeywell CT1501 Electromechanical Fuel Saver Thermostat Instruction Manual
GENERAL LIFE FH100 Underfloor Heating Thermostat User Manual
DAIKIN One Lite Smart Thermostat User Guide
TRU COMPONENTS TC-NTL-ExT6 Hazardous Area Thermostat Instructions
HERSCHEL MD2 Wi-fi Enabled Wired Thermostat Instruction Manual
Carrier EB-STATE7ICR-01 Ecobee for Smart Thermostat Owner’s Manual
American Standard ACONT103 NP Non Programmable Heat Pump Thermostat Instruction Manual
ICM CONTROLS SC2010 N-L Non Programmable Electronic Thermostat Instruction Manual
Honeywell Home T10 Programmable Smart Thermostat Installation Guide