Home > SUNDIRECT > SUNDIRECT Smart2.0 SDUM23001 Battery Back-Up Wireless thermostat Instruction Manual

SUNDIRECT Smart2.0 SDUM23001 Battery Back-Up Wireless thermostat Instruction Manual

3. Operation  
3.1 Pair to the receiver  
All “Plus” range heaters have a built-in  
thermostat receiver-Receiver01 on the backside  
of the panel. On the right, see the drawing of  
the signal lights and button of Receiver01. The  
following is a detailed description of the  
buttons and signal lights:  
1.Pair status signal light (green light)  
2.Heating status signal light (red light)  
3.“P” button  
4. Power switch  
Step1: Plug your heater to an electricity outlet, switch the Power switch of  
Receiver01 on, double press the “P” button and the “Pair signal light” will  
start to flash and is ready for pairing.  
Step2: Power-off the Smart2.0, long press the “SET” button. The “PAIR” signal  
will show on the screen of the remote control. Wait until the “Pair signal  
light” stops flashing and glows green to finish the pairing.  
Note: Once Receiver01 and Smart2.0 are paired, the pair signal light will  
always be on and the Receiver01 will be only commanded by the Smart2.0.  
One Receiver01 can only pair to one Smart2.0, however, one Smart2.0 can be  
paired to up to 10pcs Receiver01 if they are in the same room.  
3.2 Time settings and temperature calibration  
Power on Smart2.0. Press the “SET”  
button for 3 seconds to enter the  
settings.  
The screen on the thermostat will  
show as below and the minutes of  
the timer setting will start to flash.  
4
GeneralDetails
NameSUNDIRECT Smart2.0 SDUM23001 Battery Back-Up Wireless thermostat Instruction Manual
MakeSUNDIRECT
LanguageEnglish
FiletypePDF (Download)
File size0.22 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

SUNDIRECT Smart2.0 SDUM23001 Battery Back-Up Wireless thermostat Instruction Manual